Advertisement
Undetected water can cause thousands of dollars in damage. Protect your home from potential water damage by keeping a Leak Alert ™ water detector anywhere flooding is a potential danger—near aquariums, sump pumps, plumbing, washing machines, water heaters, toilets, basements, and garages.
Insert a coin between top and bottom halves of case. Turn coin to separate.
Connect 9-V battery to clip.
Position battery according to the diagram on the right. Proper battery position will allow the unit to float in the event of a flood. Securely close case.
Wet your finger and touch the two sensing contacts.
A loud, continuous alarm will sound. Dry the contacts to stop the alarm.
Water detector will also beep to indicate low battery.
Place Leak Alert ™ water detector facing up and flat against the surface, with metal sensing contacts down.
Leak Alert ™ water detector will not function properly with contacts up.
Leak Alert ™ water detector will float (if battery is inserted according to diagram inside battery compartment) and alarm will sound for life of battery, up to 72 hours.
Situation | Probable Cause | Solutions |
False alarm sounds. |
|
|
Unit does not sound alarm even when touching water. |
|
|
Unit does not float. |
|
|
REPLACE BATTERY AND RETEST UNIT ANNUALLY.
Leak Alert and Zircon are registered trademarks or trademarks of Zircon Corporation.
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download Zircon Leak Alert - Electronic Water Detector Manual
Advertisement
Thank you! Your question has been received!
Need Assistance?
Do you have a question about the Leak Alert that isn't answered in the manual? Leave your question here.