Panasonic WJ-RT416 Instructions Manual page 4

c
Connect the blue connectors of 12-pin and 13-pin cables that are supplied to the corresponding blue connectors
of the CODEC board below the Data Multiplex Board. Then, connect the blue connectors of 4-pin and 8-pin
cables that are supplied to the corresponding blue connectors of the CPU board.
v
Set all the switches (S1 - S4) on the main board of the recorder to "OFF".
b
Secure the Data Multiplex Board with the attached 4 studs using a box driver. Then, install the additional Data
Multiplex Board (this product) on the secured Data Multiplex Board with the 4 screws that were removed in the
step 2.
4
Data Multiplex board
ON ON
1 2 1
Codec board
12-pin connector
13-pin connector
8-pin connector
ON ON
2 1 2
Extension Data Multiplex board (this unit)
Stud
4-pin connector
CPU board
1 2 OFF