Sennheiser RS 2000 Instruction Manual page 22

Wireless tv headphone system
Hide thumbs Also See for RS 2000:
Table of Contents

Advertisement

If a problem occurs ...
If a problem occurs ...
Problem
Possible cause
The transmit-
No connection to the power
ter does not
supply system.
switch on
The rechargeable battery is
empty.
The head-
phones cannot
The rechargeable battery is
be switched on
deep discharged.
No connection to the power
supply system.
The audio plug is not properly
connected.
The audio source is switched
off.
The volume of the analog audio
No sound
source is either set to the mini-
mum or is on mute.
The audio cable is defective.
The stethoset receiver is not
correctly paired with the trans-
mitter (e.g. additional stethoset
receiver/receiver).
The stethoset receiver is out of
the transmitter's range.
The signal is shielded.
Occasional
sound drop-
outs
There are interfering devices
(e.g. WiFi router, Bluetooth
devices or microwaves) in the
vicinity.
The volume on the stethoset
receiver is adjusted too low.
Sound too low
The volume of the analog audio
source is adjusted too low.
22 |
RS 2000
Possible solution
Check the connections of the
power supply unit.
Recharge the rechargeable bat-
tery.
Recharge the rechargeable battery
for several hours. If the recharge-
able battery is deep discharged,
the charging process might take a
while to start (up to 1 hour).
Check the connections of the
power supply unit.
Check the audio plug connection.
Switch the audio source on.
Increase the volume on the audio
source to at least a medium level/
deactivate the muting function on
the audio source.
Replace the audio cable.
Pair the stethoset receiver with the
transmitter again.
Reduce the distance between the
stethoset receiver and the trans-
mitter.
Remove obstacles between the
transmitter and the stethoset
receiver.
Change the position of the trans-
mitter or of the receiver.
Separate the transmitter from
other wireless devices by at least
50 cm/20".
Increase the volume on the ste-
thoset receiver.
Increase the volume of the analog
audio source to at least a medium
level (approx. 1 V
).
rms
Page
12
13
12
9
20
8
16

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tr 2000Rr 2000

Table of Contents