Operation; Maintenance - Grizzly G0937 Owner's Manual

2. Select 'Cutting' or 'Drill/Mill' by turning the power supply switch (C) as your operation requires.
3. Set the Forward/Off/Reverse switch on the main control panel to the 'Forward' position.
4. For cutting, select either manual or automatic feeding with the clutch, as operation requires.
IMPORTANT: This should ALWAYS be a deliberate, conscious action.
5. Start the machine as described in above section.
6. If the operation is finished or the machine is to be left unattended, turn the Forward/Off/Reverse
switch to the OFF position, then disconnect machine from power.
ATTENTION: The power supply system of this machine has an automatic overload protective device. If
cutting or drilling too deep, the system will stop working, and a yellow indicator (on the main panel) will
light. Turn variable-speed control knob (E) fully left and then increase speed again. The system will
work and the yellow indicator will turn OFF.
ALWAYS turn the machine OFF and disconnect power BEFORE attempting
to change any settings or make any adjustments.

OPERATION

During operation:
Do not exceed 0.0010" (0.25mm) depth of cut.
Do not exceed 3/8" (10.00mm) as your drilling diameter.
IMPORTANT: Your left hand should always be free in order to hit the Emergency Stop switch
should it become necessary.

MAINTENANCE

For maximum performance, it is essential that the lathe is properly maintained.
BEFORE USE
Always inspect before use. Any damage should be repaired and misadjustments rectified. Damage to
machined surfaces should be repaired with an oil stone. Test by hand to ensure smooth operation of all
parts before use.
Inject a few drops of oil to the oilways at both leadscrew bearing (at each end bracket) once or twice
during the day if used continuously. It will be necessary to remove the change gear cover in order to oil
the left-hand bearing.
Also apply a few drops of oil to the compound slide oilway, located on the slide top surface, between the
two hex bolts.
CAUTION:
16