Advertisement
Operating Instructions
Read the ENTIRE WARNING section at the beginning of this manual including all text under
subheadings therein before set up or use of this product.
Note: For additional information regarding the parts listed in the following pages, refer to the
Parts List and Diagram on page 4.
Draining Fluid
1. Attach 8mm Hose B (14) to Quick Hose Coupler
(1) on Suction Gun. Use Hose Coupler (12) and
Extension Hose A (11) to extend hose length if
needed.
2. Submerge the Hose as far as possible into the
lubricant to be transferred.
3. Hold onto the Tube (2) with one hand and grasp the
Handle (8) with the other hand.
To Fill With Fluid
1. Fill the Tube using the above steps.
Maintenance
Procedures not specifically explained in this manual must be performed
only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE: Do not use damaged equipment. If abnormal noise
or vibration occurs, have the problem corrected before further use.
1. BEFORE EACH USE, inspect the general
condition of the Suction Gun. Check for:
• loose hardware
• misalignment or binding of moving parts
• cracked or broken parts
• any other condition that may affect its
safe operation.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM
IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR
MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS
QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE
ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY
STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND
LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY
ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS
THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
Item 59513
For technical questions, please call 1-888-866-5797.
4. Pull up on the Handle to create suction
and fill up the Tube. Place cap on the
hose end to prevent dripping.
5. Place the Suction Gun over a collection receptacle
(not included) that can be closed and covered
for transfer. Remove cap and push down on the
Handle to move lubricant out from the Tube into the
collection receptacle.
2. Push down on the Handle to inject lubricant through
the Hose into the transmission, clutch or differential.
2. AFTER USE, wipe unit off using a clean, dry cloth.
3. Store the Suction Gun in a clean, dry
location out of reach of children.
Page 3
Advertisement
