Maddox MBD1 Owner's Manual page 3

Instructions
Note: This Kit will not repair ALL
dents, regardless of size. It will not
work on aluminum surfaces.
1. Insert Glue Stick into Glue Gun.
Plug Glue Gun into grounded
120VAC outlet. Allow to warm up
for ten to fifteen minutes before use.
Note: Do not use crafting glue sticks.
Slide Hammer
1. Place Slide Hammer over end of
Pull Tab. Slide it backward and
forward until dent is raised.
2. Remove Slide Hammer.
T-Puller
1. Place T-Puller over end of Pull Tab.
Pull it backward until dent is raised.
2. Remove T-Puller.
Item 58450
For technical questions, please call 1-888-866-5797.
2. Using clean cloth (not included),
clean dent area with Release Agent.
3. Choose Pull Tab the
same size as dent.
4. Apply glue to Pull Tab then quickly
place Pull Tab on center of dent
and hold there for ten seconds.
5. Wait two to three minutes for glue
to set before applying puller.
3. Remove Pull Tab. If necessary,
spray Release Agent around
Pull Tab to soften glue and use
Scraper to remove glue.
4. Clean area thoroughly to remove
Release Agent residue.
3. Remove Pull Tab. If necessary,
spray Release Agent around
Pull Tab to soften glue and use
Scraper to remove glue.
4. Clean area thoroughly to remove
Release Agent residue.
Page 3