Download
Share
Print this page
Worx Nitro WG385E Safety And Operating Manual
  1. Manuals
  2. Brands
  3. Worx Nitro Manuals
  4. Chainsaw
  5. WG385E
  6. Safety and operating manual

Worx Nitro WG385E Safety And Operating Manual

Cordless chainsaw
Hide thumbs Also See for WG385E:

Advertisement

Quick Links

Download this manual
SAFETY AND OPERATING MANUAL
ORIGINAL INSTRUCTIONS
WG385E
Cordless Chainsaw
WG385E.X

Advertisement

loading
Need help?

Need help?

Do you have a question about the WG385E and is the answer not in the manual?

Questions and answers

Related Manuals for Worx Nitro WG385E

Summary of Contents for Worx Nitro WG385E

  • Page 1 SAFETY AND OPERATING MANUAL ORIGINAL INSTRUCTIONS WG385E Cordless Chainsaw WG385E.X...

  • Page 3: Table Of Contents

    Do not force the power tool. Use the correct grounded. power tool for your application. The correct c) Do not expose power tools to rain or wet power tool will do the job better and safer at the WG385E Cordless Chainsaw WG385E.X...
  • Page 4 Do not use a battery pack or tool that is g) When cutting a limb that is under tension , be damaged or modified. Damaged or modified WG385E Cordless Chainsaw WG385E.X...
  • Page 5 Do not rely exclusively upon the safety devices WG385E Cordless Chainsaw WG385E.X...
  • Page 6 Remove the small limbs in one downhill after it is felled. cut as illustrated in Figure 2. Branches under tension WG385E Cordless Chainsaw WG385E.X...
  • Page 7 When the log is supported on one end, as illustrated in Figure 4, cut 1/3 the diameter from the underside Figure 6 ( underbuck) (1). Then make the finished cut by overbucking (2) to meet the first cut. Figure 4 WG385E Cordless Chainsaw WG385E.X...
  • Page 8 Waste electrical products must not http://abr.business.gov.au. be disposed of with household waste. ABN of Positec Australia Pty Limited Please recycle where facilities exist. is 14 101 682 357 Check with your local authorities or retailer for recycling advice. WG385E Cordless Chainsaw WG385E.X...
  • Page 9 19 20...
  • Page 10 Kink...
  • Page 11 3-5mm 100%...
  • Page 12 Click! Click!
  • Page 13 Injecting grease to lubricate...

  • Page 14: Component List

    = 85.9 dB(A) = 3.0 dB(A) 3.TECHNICAL DATA A weighted sound power = 101.2dB(A) = 3.0 dB(A) Type WG385E WG385E.X (3 - designation of machin- Wear ear protection. ery, representative of Chainsaw) WG385E WG385E.X *** VIBRATION INFORMATION Voltage MAX (2x20V Max.)**...

  • Page 15: Assembly

    ● Removing the battery pack before adjusting saw chain tension. ● Cutting edges on chain are sharp. Use protective gloves when handling chain. ● Maintain proper chain tension always. A loose WG385E Cordless Chainsaw WG385E.X...

  • Page 16: Operation

    Allow IMPORTANT: To allow venting of the oil tank, time for the battery to cool down before recharging. small breather channels are provided between NOTE: Always fully charge the two batteries at same WG385E Cordless Chainsaw WG385E.X...
  • Page 17 (3) Use both hands to grip saw. Always use left hand is illuminated. Please check and charge the to grip front handle and right hand to grip rear battery pack. handle. Use a firm grip. Thumbs and fingers must WG385E Cordless Chainsaw WG385E.X...
  • Page 18 Do not use Chainsaw if damage affects safety or operation. Have damage How to use Saw Safely repaired by authorized service center. To locate an 1. Use the Chainsaw only with secure footing. authorized service center, visit www.worx.com. WG385E Cordless Chainsaw WG385E.X...

  • Page 19: Environmental Protection

    10 Corporate Blvd Bayswater , VIC 3153, Australia Replace chain when cutters are too worn to sharpen or when chain stops. Only use replacement chain noted in this manual. Inspect guide bar before sharpening chain. A worn WG385E Cordless Chainsaw WG385E.X...

  • Page 20: Troubleshooting Table

    Chain/chain bar No oil in Refill oil. over-heats. reservoir. Clean cap. Vent in oil filler Clean oil cap clogged. passage Oil passage outlet. clogged. Adjust chain Chain is over tension. tensioned. Sharpen chain Dull chain. or replace. WG385E Cordless Chainsaw WG385E.X...

  • Page 21: Declaration Of Conformity

    Positec (UK & Ireland) Ltd, PO Box 6242, Newbury, RG14 9LT, UK On behalf of Positec declare that the product Description Battery-powered chainsaw Type WG385E WG385E.X (3 - designation of machinery, representative of Chainsaw) Function Cutting wood Complies with the following Directives:...
  • Page 24 After-sales Service and Application At www.worx.com you can order spare parts or arrange the collection of a product in need of servicing or repair. Tel. Service: 0345 202 9679 E-Mail: customerservices@worxtools.com www.worx.com Copyright © 2022, Positec. All Rights Reserved. AR01589202...

This manual is also suitable for:

Wg385e.x