Husqvarna HA200 Operator's Manual page 7

• Always wear protective, non-slip boots.
• Always wear working clothes and heavy-duty long
trousers.
• Never wear loose clothing or jewellery.
• Make sure your hair does not hang below shoulder
level.
Safety devices on the product
WARNING:
instructions that follow before you use the
product.
In this section the product's safety features, its purpose
and how checks and maintenance should be carried
out to ensure that it operates correctly. See instructions
Introduction on page 2 to find where
under the heading
these parts are located on your product.
The life span of the product can be reduced and the risk
of accidents can increase if product maintenance is not
carried out correctly and if service and/or repairs are not
carried out professionally. If you need further information
please contact your nearest servicing dealer.
WARNING:
defective safety components. The product's
safety equipment must be inspected and
maintained as described in this section.
If your product fails any of these checks,
contact your service agent to get it repaired.
CAUTION:
on the machine requires special training.
This is especially true of the machine's
safety equipment. If your machine fails
any of the checks described below you
must contact your service agent. When
you buy any of our products we guarantee
the availability of professional repairs and
service. If the retailer who sells your
machine is not a servicing dealer, ask him
for the address of your nearest service
agent.
1183 - 002 - 16.01.2023
Read the warning
Never use a product with
All servicing and repair work
To do a check of the hand guard (HA200, for gasoline
products only)
The hand guard prevents hands from coming in contact
with the moving blades, for example, if the operator
loses grip on the front handle.
1. Check that the hand guard is fitted correctly.
2. Check that the hand guard is undamaged.
To do a check of the blades
To ensure good cutting results it is important that the
contact pressure between the blades is correct.
1. The contact pressure is adjusted by turning the
screws on the underside of the bar clockwise as far
as they will go.
2. Then turn the screws anticlockwise a 1/4 turn.
3. Lock the screws using the locking nut on the top of
the bar.
4. Check that the screws are loose enough to allow the
washers under the screw heads to slide sideways.
5. When the blades are correctly adjusted the play
between the blades should be 0,2–0,4 mm,
measured at the screws.
6. The edges of the blades are too hard to be filed. Dull
blades should be sharpened using a grinder.
7. Replace the blades if they are bent or damaged.
Hot surface
The gear housing gets hot when the product has been
in use. Do not touch the gear housing to avoid burning
yourself.
7