Valley Electronics Daysy Instructions For Use Manual page 10

10
Step 1: Charge your Daysy
1. Connect your Daysy to the micro USB cable supplied in your package and
the cable to a USB port. Make sure it is a 5V port that does not supply more
than 1A current.
2. Press the activation button to see the charging status. The blue lights
moving from bottom to top indicate Daysy is charging. Daysy will enter
standby mode after 60 seconds but will continue charging.*
3. All blue lights remain illuminated when Daysy is fully charged. Simply press
the activation button once to check the status. (A low battery condition is
indicated by all blue lights flashing.)
4. Disconnect the cable from your Daysy. You can now begin using your Daysy.**
* Do not measure or try to sync whilst Daysy is charging.
** You can start measuring at any time in your cycle.