End Of Charging Procedure; Disconnecting The "Mode 2" Charging Cable - Alfa Romeo Tonale Quick Manual

NOTE The charge procedure is
interrupted when opening the bonnet: a
dedicated message will be shown on the
instrument panel display. The charge
will be reactivated when the bonnet is
closed correctly.
WARNING Use only the charging
cable supplied (where provided)
recommended by FCA.
WARNING The high-voltage battery
must be charged in accordance with
the maximum ampere rating allowed by
local and national recommendations for
charging electric/hybrid cars.

END OF CHARGING PROCEDURE

The charging procedure ends when all
the LEDs (1) fig. 35, next to the charging
socket, are on green continuously
(during charging, the first LED will
flash, while the other LEDs will be on
continuously).
2
1
35
DISCONNECTING THE "MODE 2"
CHARGING CABLE
During the charging procedure the
cable is automatically locked on the
charging port in the car.
To complete the charging, proceed as
follows:
 unlock the doors of the car allowing
the charging cable to unlock
 disconnect the cable from the
vehicle charging port by grasping
the handle of the charging
connector and avoiding to pull the
cable directly
 reposition the protective cover of
the charging port
 close the charging flap, making sure
it locks properly
 roll up the charging cable correctly,
repositioning the protective cover
correctly on the charging connector
(where provided). When rolling up,
take care not to damage the cable.
Then place the cable, together with
the charging kit, inside the housing
located inside the boot
9650350
WARNING Before disconnecting the
charging connector, make sure that the
doors are unlocked. If the door is locked,
the charging connector locking system
does not allow disconnection.
WARNING
29) In order to reduce the risk of electric
shock or damage to the device, special
care should be taken when cleaning:
ALWAYS unplug the device from the
domestic power supply socket and car
ports.
30) The charging current level ("Level
1" / "Level 2" / "Level 3", etc.) can only
be changed via the Alfa Connect system
display (see the "Alfa Connect" chapter
in the "Multimedia" section of the Owner
Handbook for more information). The
default charge level set is "Level 3". For
countries in which the 13A "Mode 2"
charge cable can be used, if the domestic
power socket IS NOT CERTIFIED, it is
recommended to set "Level 4" charge
to the maximum, which corresponds
to approx. 10A. For the list of country-
specific cable types refer to what is
indicated in the "Mode 2 cable variant
table".
23