Installation and Operating Instructions
LT23 Adjustable Sprayer Rack
for Landscape Trailers
Safety Precautions
This symbol points out important safety instructions which, if not
followed, could endanger the personal safety and/or property
of yourself and others. Read and follow all instructions in this
manual before attempting to install or operate this sprayer.
Failure to comply with these instructions may result in personal
injury. When you see this symbol. HEED ITS WARNING!
WARNING
Read and follow all instructions in this manual before attempting
to install or use this sprayer rack. It is the installers sole
responsibility to assure that the rack is installed safely and
securely to a component that will adequately support the
equipment. Failure to comply with these instructions could
endanger the personal safety and/or property of yourself and
others.
WARRANTY
Buyers Products Co. warrants all truck/trailer hardware manufactured or
distributed by it, to be free from defects in material and workmanship for a
period of one year from date of shipment. Parts must be properly installed
and used under normal conditions. Any product which has been altered,
including modification, misuse, accident or lack of maintenance will not be
considered under warranty. Normal wear is excluded. The sole responsibility
of Buyers Products Co. under this warranty is limited to repairing or replacing
any part or parts which are returned, prepaid, and are found to be defective
by Buyers Products Co. Authorization from Buyers Products Co. must be
obtained before returning any part. No charges for transportation or labor
performed on Buyers' products will be allowed under this warranty.
Assembling/Fitting the Adjustable Sprayer Rack
to Your Backpack Sprayer
Tools Required:
• (1) 9/16" Socket and Ratchet
2
10
9
5
1. Assemble Backbone (item 4) to Base (item 1) with two 3/8"
Carriage Screws (item 6), two Washers (item 9) and two Lock
Nuts (item 10) as shown in figure.
2. Assemble Side Wall (item 5) to Base (item 1) with two 3/8"
Carriage Screws (item 6), two Washers (item 9) and two Lock
Nuts (item 10) as shown in figure. Side Wall tab should be
UNDERNEATH Base.
ATTENTION: Side Wall (item 5) can be placed on either side
of the Sprayer Rack. Install Side Wall on the OPPOSITE side
of the pump handle of the sprayer.
3. Stand rack upright and place the sprayer on the Base (Item
1) with the shoulder straps against the Base wall. Confirm that
the Side Wall (item 5) is on the opposite side of the pump arm. If
not, redo step 2.
1
www.buyersproducts.com
Phone (440) 974-8888
Fax 800-841-8003
4
3
1
6