Table of Contents
Advertisement
Connect the corresponding power cord, and video
5.
cable.
Power on the camera to check whether the image
6.
on the monitor is gotten from the optimum angle. If
not, adjust the camera according to the figure below
to get an optimum angle.
Rotation Position
[0° to 360°]
1). Loosen the P screw to adjust the pan position [0°
to 360°]. Tighten the screw after completing the
adjustment.
2). Loosen the T screw to adjust the tilt position [0°
to 180°]. Tighten the screw after completing the
adjustment.
3). Loosen the R screw and rotate the camera [0° to
360°]. Tighten the screw after completing the
adjustment.
2.1.2 Ceiling/Wall Mounting with Junction Box
Before you start:
You need to purchase a junction box separately.
Steps:
1. Paste the drill template on the ceiling/wall.
2. Drill screw holes and the cable hole in the
ceiling/wall according to the holes of the drill
template.
Figure 2-4
3. Take apart the junction box, and align the screw
holes of the bullet camera with those on the
Junction box' cover.
4. Fix the camera on the junction box's cover with
supplied screws.
Fix the Camera on the Junction Box's Cover
Figure 2-5
5. Attach the junction box body to the ceiling/wall by
aligning the screw holes of the junction box.
3-axis Adjustment
Figure 2-3
Drill Template of Junction Box
Pan Position
[0° to 360°]
P Screw
Tilt Position
[0° to 180°]
T Screw
R Screw
Junction
Box Cover
Advertisement
Table of Contents
