JET sells through distributors only. The specifications listed in JET printed materials and on official JET website are given as general information and are not binding. JET reserves the right to effect at any time, without prior notice, those alterations to parts, fittings, and accessory equipment which they may deem necessary for any reason ®...
Page 3
Warnings For your own safety, read this instruction manual before operating the tool. Wear Eye Protection • KEEP GUARDS IN PLACE and in working order. • REMOVE ADJUSTING KEYS AND WRENCHES. Form the habit of checking to see that keys and adjusting wrenches are removed from the tool before turning it on.
Before Assembly 1. Unpack the taper attachment from the box. 2. Disassemble the taper attachment and clean thoroughly with a mild solvent. 3. Lightly oil all surfaces with machine tool oil. Figure 1 Assembly 1. Remove two hex bolts (A, Figure 1) from the bracket.
Page 5
7. Center the cross feed screw (A, Figure 5) to the hole in the feed block. Turn the cross feed handle to make sure there is no resistance. 8. Tighten four M10x50 hex socket cap screws on the taper attachment main body after the cross feed screw has been centered.
17. Slowly move the carriage back until the clamp rod is through the hole in the clamp. Note: If the clamp rod is not low enough, use shims, and adjust accordingly. 18. Install the washer and nut (D, Figure 8). Tighten all bolts.
Page 8
TAK-ZX Taper Attachment Kit – Parts List Index No Part No Description Size 1 ....84-3001-00 ....Slide Base...................... 1 2 ....84-3002-00 ....Slide Bracket....................1 3 ....TS-1505071 ....Hex Socket Cap Screw ..........M10x50 ......4 4 ....