Advertisement
Signal strength indicator (RSSI)
Wireless network indicator (WLAN)
Running status indicator (RUN)
10.
Grounding screw
11.
2.4G/5G dual-band antenna interface (WIFI1-WIFI2)
【Mounting Dimension】
Unit: mm
Model I, Model II
Model III, Model IV
Notice Before Mounting:
Don't place or install the device in area near water or
moist, keep the relative humidity of the device
surrounding between 5%~95% without condensation.
Before power on, first confirm the supported power
supply specification to avoid over-voltage damaging the
device.
The device surface temperature is high after running;
please don't directly contact to avoid scalding.
【DIN-Rail Mounting】
The product adopts 35mm standard DIN-Rail mounting which
is suitable for most industrial scenes, mounting steps as
follows:
- 3 / 6 -
Check whether the DIN-Rail mounting kit that
comes with the device is installed firmly.
Insert the bottom of DIN-Rail mounting kit (one side
with spring support) into DIN-Rail, and then insert
the top into DIN-Rail.
Tips:
Insert a little to the bottom, lift upward and then insert to
the top.
Check and confirm the product is firmly installed on
DIN-Rail, then mounting ends.
【Disassembling DIN-Rail】
Power off the device.
After lifting the device upward slightly, first shift out
the top of DIN-Rail mounting kit, and then shift out
the bottom of DIN-Rail, disassembling ends.
【Wall-mounted Device Mounting】
Adopt M3 screw to install the left/right mounting
board on the device side board.
Advertisement
