Exposure OLAS GUARDIAN Troubleshooting

Troubleshooting
FOR FIRMWARE VERSION 2.0+
If you experience a false alarm whilst testing the system, it is likely because the connection between the Tag and the
Guardian was broken for longer than 3 seconds. If this occurs carry out the following steps to adjust your system.
1. Accept the alarm with the OLAS App.
Alert Settings
Siren (Default)
3. Cancel the alarm on the Guardian by pressing the
control switch once.
Detection Time
2
1
Alert Delay
4
1
Pause Alert Sound
Connected to
(Guardian only)
5.
Adjust the Alert Delay to 4 seconds. This means when the
connection is broken the Guardian will give a warning for 4
seconds, with fast beeps, before it activates the alarm. This can
help you to understand what action is breaking the connection.
If the Tag is brought back into range during this period the
alert is canceled.
Tom
Overboard!
Step 1
Press and hold the MOB button
on your GPS Chart Plotter
Step 2
Send a MOB DSC alert
using your VHF
Continue to recovery
Sound
Volume
(seconds)
15
(seconds)
30
2. Bring the Tag within 1 metre of the Guardian.
0438 Near
4. Navigate to the Alert Settings in the OLAS App.
6. Walk to the location where the Tag previously set off
the alarm and then continue walking around the vessel.
If you hear the fast beeping walk back and the Tag
should reconnect and cancel the alarm.
exposureolas.com
Solo Mode
Vessel
Information
0438 Far
Alert Settings
Device Selection
FAQ's
Close OLAS
Firmware Update
Online Tutorials
MOB MOB
0438 Far
MOB
Alert Settings
Sound
Siren (Default)
Volume
Detection Time
(seconds)
7
2 15
Alert Delay
(seconds)
4
2 30
Pause Alert Sound
Connected to
(Guardian only)