Exposure OLAS CORE Testing

Testing the alarm
FOR FIRMWARE VERSION 2.0+
1. Connect the OLAS app to the Core. For more
information on how to do this please refer to the Core
Setup Instructions.
3. Switch off the OLAS transmitters.
OLAS tag: press the button for 4 seconds, until a red flash is seen.
OLAS Float-On: press the button for 4 seconds until the bi-colour
turns red.
4. If testing with an OLAS Tag or OLAS Float-ON the
alarm will occur after your set 'Alert Time' which has a
default of 3 seconds. If testing with an OLAS T2 tag the
alarm will occur immediately after it is switched off.
MOB
Tom
Overboard!
Step 1
Press and hold the MOB button
on your GPS Chart Plotter
Step 2
Send a MOB DSC alert
using your VHF
Continue to recovery
exposureolas.com
0438 Near
1152 Near
0347 Near
MOB
2. Ensure all OLAS transmitters are seen on the OLAS app
homescreen.
Solo Mode
Vessel
Information
0438 Near
Alert Settings
Device Selection
FAQ's
Close OLAS
Firmware Update
MOB
4. If using an OLAS T2 go to 'Alert Settings' in the menu
and select the alert function for the OLAS T2. Now
when you switch off your OLAS T2 tag it will activate
the alarm immediately.
5. Press the control switch on the Core once. This puts the
system into pause.
ID: 0438
0347
Alert Settings
Sound
Siren (Default)
Volume
Detection Time
(seconds)
7
2
Alert Delay
0438 Far
(seconds)
4
2
Switch Active
(seconds)
5
5
Pause Alert Sound
OLAS T2 Function
Online Tutorials
MOB
Tom
Overboard!
OR Step 1
Press and hold the MOB button
on your GPS Chart Plotter
Step 2
Send a MOB DSC alert
using your VHF
Continue to recovery
15
30
60