Advertisement
7. Troubleshooting:
Problem
A. little or no material flow
B. material leaking
C. atomization is too coarse
D. spray jet pulsates
E. pattern runs or sags
F. too much over-spray
G. pattern is very light and splotchy
H. large cloud of paint
8. Warning!
1. Keep your workplace clean and tidy, never use the tool in hazardous areas that contain
flammable liquids, gases or dust.
2. Only use paints, solvents or other materials with a flash point of 73 °F(22C) or higher.
3. Never point the spray gun at other person or animal. In the event of an injury, seek immediate
medical attention.
4. Always read the paint manufacturer's thinning instructions before use.
5. You must clean the spray gun thoroughly after each use.
6. Do not pull the power cord to move this tool.
Marketed by :
Manik Radiators Pvt. Ltd.
Shed No.3, Plot No. 126/1 2B, Village Horale, Khopoli Pen Road,
Khalapur, Raigad 410203, Maharashtra, INDIA Tel.: +91 22 660 47 000
E-mail: info@pilotindia.com • www.pilotindia.com
Cause
1. nozzle clogged
2. suction tube clogged
3. material volume setting may have
turned too far to the right
4. suction tube loose
5. material is too thick
6. inconsistent paint
7. container is loose
1. nozzle loose
2. nozzle worn
3. nozzle seal worn
4. material build-up on spray pattern
dial and nozzle
1. viscosity of material too high
2. material volume too large
3. nozzle clogged
4. too little pressure build-up in container 4. tighten container
1. material in container running out
2. material is too thick
1. applying too much material
1. gun too far from spray object
2. too much material applied
1. moving the spray gun too fast
1. gun too close to surface
Solution
1. clean
2. clean
3. turn to the left
4. insert
5. check viscosity
6. strain paint
7. tighten the container
1. tighten
2. replace
3. replace
4. clean
1. thin the material
2. turn to the right
3. clean
1. refill
2. check viscosity
1. adjust material flow or increase
movement of spray gun
1. reduce distance
2. turn material volume setting
to right
1. adjust material flow or decrease
movement of spray gun
1. move gun away from surface
and reduce paint flow
Advertisement
