Related Manuals for Pilot Power E22
Summary of Contents for Pilot Power E22
- Page 1 Electric Spray Gun Conformity to European Standards INSTRUCTION MANUAL Before using the gun, please read this manual thoroughly. Improper use of the gun can cause damage or a fatal injury. 220-240V~ 50 Hz 550 W...
-
Page 3: Exploded View
22016 Spanner 22037 Lock Catch 22017 Viscocity Cup 22038 Spray Housing Right Cover 22018 2. Technical Parameters: Model: E22 Rated power: 550W Spray distance: 200-250mm Rated Width: 200-300mm Voltage 220-240V Frequency: 50HZ Viscosity: 8-12s Rated speed: 30000RPM Paint capacity: 800ml Air flow: 160L/MIN Wire length: 1.8m... -
Page 4: How To Use
4. How to Use: Before using the electric spray gun, material preparation is the first stage. Please refer to the thinning chart and picture. Material Run out time (Sec) Oil Enamel 25-60 Oil based primer. 30-60 Oil stain no thinning required Clear sealer no thinning required Polyurethane... - Page 5 b) If spray in a downward direction, the angled end of the suction tube should be pointing towards the front of the gun. Suction Tube 4-3) Pour material into container, make sure not to exceed 800ml 4-4) Remove the motor a) Hold the gun with your hand and press the latch in the direction of the arrow.
- Page 6 4-6) Adjust the needle adjusting screw to meet your requirement. a) Adjust the screw to left to decrease paint volume, lower paint thickness b) Adjust the screw to right to increase paint Adjusting Screw volume, increase paint thickness 4-7) Spray length adjustment: Turn this knob to adjust the round shape from vertical to horizontal.
- Page 7 5. How to Spray Properly: EVEN COAT THROUGHOUT Correct: Keep stroke smooth and at even speed. Incorrect: Do not flex wrist while spraying. 6. Replace Nozzle and Needle: When disassembling the nozzle, please pull the trigger first, then press and remove the nozzle. a) As shown in the figure, rotate to remove the needle b) As shown in the figure, rotate to set up the needle...
-
Page 8: Troubleshooting
7. Troubleshooting: Problem Cause Solution A. little or no material flow 1. nozzle clogged 1. clean 2. suction tube clogged 2. clean 3. material volume setting may have turned too far to the right 3. turn to the left 4. suction tube loose 4.