Table of Contents
Advertisement
CANCEL
STOP+/–
PROG.
ATTENTION
If there is a conflict in the timer schedule and one program
overlaps with another, only the parts shown below in gray
will be recorded.
Pattern 1: The program with the lower program number
will be recorded.
10:00
Program 1
Program 2
Pattern 2: The program that is broadcast earlier will be
recorded.
10:00
Program 1
Program 2
Pattern 3: The program that is broadcast earlier will be
recorded, followed by the remaining portion of
the other program.
10:00
Program 1
Downloaded from:
https://www.usersmanualguide.com/
1
2
3
2
4
5
6
7
8
9
0
4
1
OK
11:00
12:00
CH10
Not recorded
CH40
11:00
12:00
CH10
Not recorded
CH40
11:00
12:00
CH10
Program 2
CH40
Not recorded
CHECK PROGRAM DATA
5
The PlusCode number you
entered and the matching
Timer-Recording informa-
tion is displayed on the
Program screen. Check to
make sure it's accurate.
● To change the stop time,
● To timer-record daily or weekly serials, press DAILY
TIMER
● If you made a mistake, press CANCEL to access the
● If the PlusCode number you inputted is incorrect,
SET TAPE SPEED
6
Press SP/EP.
RETURN TO NORMAL
SCREEN
7
Press PROG. or OK. "PROGRAM COMPLETED"
appears on the screen for about 5 seconds, then normal
screen appears.
ENGAGE TIMER MODE
8
Press TIMER. The VCR turns off automatically and "‰"
is displayed on the display panel.
IMPORTANT
If you have moved to a different area or if a broadcasting
station's channel number has been changed, the wrong
VCR or CABLE CH number will be displayed on the VCR
Plus+ Program screen in step 5. When this happens, set the
correct the Guide Channel number for that station.
(
pg. 26, "VCR Plus+ Setup")
NOTES:
● To disengage the timer before recording starts, press TIMER
again. Pressing once more re-engages it.
● In case of a power failure after programming, the VCR's
memory backup keeps your selections (if the lithium battery is
not exhausted).
● When timer-recording cable channels received through a
Cable Box, be sure to keep the Cable Box set to ON.
PRESS (8=DAILY, 9=WEEKLY
STOP+/– = STOP TIME, SP/EP)
PRESS (OK) TO END
press STOP +/–.
(NUMBER "8") or WEEKLY (NUMBER "9"). "DAILY"
or "WEEKLY" appears on the Program screen.
Pressing the button again makes each corresponding
display disappear.
VCR Plus+ screen again and input the correct
PlusCode number.
"ERROR" may appear on the screen to advise you of
the error. This happens when the PlusCode number is
for a program which has already passed. "ERROR" is
displayed for about 5 seconds and the VCR Plus+
screen reappears.
25
EN
PROGRAM 1
(VCR PLUS+ 12345678)
START
STOP
8:00PM
10:00PM
=
DATE
CH
12/24/98
12 SP
THU
Advertisement
Table of Contents
