Table of Contents
Advertisement
Menu adjustment
Operation
The adjustment and setting of this unit can be performed
with the on-screen menu displayed by the projector or
monitor.
Press the MENU/ENTER button
Select the adjustment item with the
3
button
.
Set the data with the
When the setting is complete, press the MENU/ENTER
button to exit the menu display.
Functions
The functions and settings for each adjustment item are shown below.
Adjustment item
RED LEVEL
BLUE LEVEL
DIGITAL ZOOM
JPEG
LOAD
SAVE
• When E on the rear panel MODE switch is set to 0, there will be no menu display. (refer to MODE on the rear panel on page 8).
• When the camera picture mode is SVGA or VGA, the definition of the menu display is reduced slightly.
• With the digital zoom magnification set to x4, the picture may be pixelated when the magnification is maximized. It is recom-
mended to normally use x2.
• The settings for SOURCE SELECT and FREEZE cannot be saved. When the power is supplied, SOURCE SELECT is set to
CAMERA and FREEZE is set to OFF.
• While the menu is displayed on the screen, settings for TEXT MODE, BW/COLOR, NEGA/POSI and LIGHTS cannot be
altered. To make alteration, first exit the menu display and then change the setting.
10
Downloaded from:
https://www.usersmanualguide.com/
1
to display the menu.
2
button
and the
4
button
and the
button
Adjusts the red level of the camera picture.
-30 to +30 (in increments of 1 step)
Adjusts the blue level of the camera picture.
-30 to +30 (in increments of 1 step)
Sets the maximum magnification of the digital zoom.
OFF/x2/x4
• The altered setting will become effective only when the ZOOM button is pressed.
Sets the compression rate of the JPEG picture captured to a personal computer via
the USB connector.
FINE
: Highest picture quality, but large file size. Normally, use this mode.
NORMAL
: The file size is between FINE and ECONOMY.
ECONOMY : Lower picture quality, but smaller file size.
FINE/NORMAL/ECONOMY
Selects the settings.
DEFAULT : Returns the current conditions to the initial values (factory-set values).
Select DEFAULT and exit the menu to start operation.
USER
: Changes the current settings to those stored in memory with the SAVE
function shown below. Select USER and press the MENU/ENTER button
to start operation.
CANCEL/DEFAULT/USER
Stores current settings in memory.
Select OK and press the MENU/ENTER button to store the settings in memory.
The stored settings will be applied the next time the presenter is powered up.
CANCEL/OK
5
.
Functions and settings
2 3 4 5 1
NEGA
BW
ON
LIGHTS
NEGA/
BW/
TEXT
MENU/
POSI
COLOR
MODE
ENTER
CAMERA
EXT IN
PICTURE MEMORY
SOURCE SELECT
Initial value
0
0
x 2
FINE
CANCEL
CANCEL
Advertisement
Table of Contents
