Connecting The Alm100; Nmea 2000 Connection; Figure 2 - Flush Mounting The Alm100 Directly To A Wall - Maretron ALM100-01 User Manual

ALM100 User's Manual
Faceplate
Mounting Screws
(x2)
Sounder Collar
Figure 2 – Flush Mounting the ALM100 Directly to a Wall
The following instructions apply wither mounting the ALM100 into an electrical box or to a wall:
1) Connect the NMEA 2000 cable to the connector on the ALM100 Alarm Module
2) Using the included ALM100 mounting screws, mount the ALM100 Alarm Module to the
wall or electrical box
3) Place the sounder gasket over the sounder on the ALM100 alarm module
4) Place the faceplate gasket over the ALM100 alarm module
5) Mount the ALM100 faceplate over the ALM100 alarm module using the included
faceplate mounting screws.
6) Screw the sounder collar onto the sounder of the ALM100 alarm module, which should
now be protruding through the large hole in the faceplate, and tighten until snug.
7) Optionally, you may install the volume control by first placing the volume control baffle
plate over the front of the sounder, then placing the volume control shutter over the
volume control baffle plate, and finally attaching both to the sounder by threading the
volume control screw into the hole in the center of the sounder.

2.4 Connecting the ALM100

The ALM100 requires a single type of electrical connection: the NMEA 2000
to Section 2.4.1).
2.4.1 NMEA 2000
®
The NMEA 2000 connector can be found on the rear of the enclosure. The NMEA 2000
connector is a round five pin male connector (see Figure 3). You connect the ALM100 to an
Page A4
ALM100 Faceplate
Faceplate Gasket
®
Connection
Appendix A – NMEA 2000 Interfacing
NMEA 2000 Cable (not
ALM100 Mounting Screws (x2)
Sounder Gasket
Volume Control Baffle Plate
Volume Control Shutter
Volume Control Screw
included)
ALM100 Alarm Module
®
connection (refer
Revision 1.1
®