Hose Clamp - Makita CE002G Instruction Manual

NOTE: When installing the wheel, be sure to attach
the flanges so that the flat side of flange faces the
wheel, and attach the ring that matches the inner
diameter of the wheel.
1
2 3
Fig.10
► 1 . Hex bolt 2. Flange 3. Ring 4. Diamond wheel
Connecting a vacuum cleaner
NOTICE:
Always close the cap when not con-
necting a vacuum cleaner.
When you wish to perform clean cutting operation,
connect a Makita vacuum cleaner to your tool.
Open the cap and connect a hose of the vacuum
cleaner.
Fig.11
► 1 . Cap 2. Dust nozzle 3. Hose 4. Vacuum cleaner
4
2
1
2
3
4
You can change the angle of the dust nozzle as shown
in the figure.
Fig.12

Hose clamp

NOTICE:
Always remove the hose clamp from
the tool when not in use.
NOTICE:
Do not open or close the hose clamp
excessively. Otherwise the hose clamp may be
broken.
For easy handling of the hose of vacuum cleaner, hose
clamp can be attached
1.
Attach the hose clamp A or hose clamp B on the
hose.
Type
Hose clamp A
Hose clamp B
Fig.13
► 1 . Hose clamp A / Hose clamp B 2. Hose
13 ENGLISH
Applicable outer diameter
of hose
ø 40 mm - ø 46 mm
(ø 1-9/16" - ø 1-13/16")
ø 35 mm - ø 40 mm
(ø 1-3/8" - ø 1-9/16")
1
2