Motion CM-12 Manual page 11

Shortly press the program button on the motor. The
4.1
blind will start stepping, indicating that program mode
has been activated.
(The blind keeps stepping until the program mode is
deactivated)
Select a desired channel for the blind using the channel
4.2
selection button on the remote control.
Press the pair button on the back of the remote
4.3
control to pair the blind with the selected channel.
The blind will shortly stop stepping, indicating that
the remote has been paired with the blind.
Repeat steps 4.1 - 4.3 to remove a blind from a channel.
Channel Selection
4. PAIR A REMOTE
Channel indicator
Pair
button
11