ULTIMATE SPEED Z30013A, Z30013B - Tyre Pressure & Depth Gauge Manual

Introduction

Familiarise yourself with the product before using it for the first time. In addition please refer carefully to the operating instructions below and the safety advices. Use the product only as described and for the indicated purpose. Keep these instructions in a safe place. If you pass the product on to anyone else, please ensure that you also pass on all the documentation.

Proper use

This appliance is intended for use in checking the air pressure and tread depth of car tyres. Any other use or modification of the device constitute improper use and may result in injury and / or damage to the device. The manufacturer is not liable for damage caused by improper use. The device is not intended for commercial use.

Description of parts

1. battery
2. symbol (tyre pressure)
3. symbol (tyre pressure)
4. symbol (tyre pressure)
5. symbol (tread depth)
6. LC-Display
7. Measuring tine (for the tyre profile depth)
8. Slider
9. Key ring
10. Air pressure sensor
11. Battery compartment cover
12. Belt clip

Supply scope

• 1 x Tyre pressure gauge with belt clip and a key ring
• 1 x Battery 3 VCR2032
• 1 x Instructions for use

Technical data

Measurement of the tyre pressure

The legal unit for pressure is Pa.

Measurement of the tread depth

Power supply

Battery: 1 x 3 V CR2032

Safety instructions

YOU SHOULD STORE ALL SAFETY INFORMATION AND INSTRUCTIONS IN A SAFE PLACE IN CASE YOU NEED TO REFER TO THEM AGAIN IN THE FUTURE!

General safety information

DANGER TO LIFE AND ACCIDENT HAZARD FOR TODDLERS AND SMALL CHILDREN!

Never allow children to play unsupervised with the packaging material. There is a danger of suffocation from the packaging material. Children frequently underestimate the dangers. Children should be kept away from the product at all times.

DANGER TO LIFE! Batteries can be swallowed, which may represent a danger to life. If a battery has been swallowed, medical help is required immediately.

• This device is not intended for use by anyone (including children) of limited physical, sensory or mental capacity or lacking experience and / or knowledge, unless they are supervised by a person responsible for their safety or have been instructed by that person in how to use the device. Children must be supervised to ensure that they do not play with the device. This is not a toy.
• Do not expose the product to
  • extreme temperatures,
  • strong vibrations,
  • heavy mechanical loads,
  • direct sunlight.
    These can otherwise damage the device.
• Please note that the guarantee does not cover damage caused by incorrect handling, non-compliance with the operating instructions or interference with the device by unauthorised individuals.
• Under no circumstances should you take the device apart.
  Improper repairs may place the user in considerable danger.
  Repairs should only be carried out by specialist personnel.

Safety information regarding batteries

• Remove the battery if you are not going to use the product for an extended period.
• 
  CAUTION! RISK OF EXPLOSION! Never recharge the battery!
• When inserting the battery, ensure correct polarity! This is indicated in the battery compartment.
• Clean the battery and appliance contact before insertion if necessary.
• Immediately remove a spent battery from the appliance.
  There is an increased risk of leakage otherwise!
• Batteries should not be disposed of with domestic waste!
• Every consumer is legally obliged to dispose of batteries according to the statutory regulations!
• 
  CAUTION! DANGER OF EXPLOSION! Keep batteries away from children; do not throw batteries into a fire; do not short-circuit the batteries and do not take them apart.
• Failure to comply with the above-mentioned information means that the battery may discharge beyond its cut-off voltage. There is then a risk of leakage. If the battery should leak into the appliance, remove it immediately to avoid damage to the appliance!
• Avoid contact with skin, eyes and mucous membranes. Upon contact with battery acid, rinse the affected area with lots of water and / or consult a doctor!

Preparing for use

Inserting the battery

Note: Before first use, pull the battery insulation strip out from between the battery and the battery compartment.

• Open the battery compartment.
• Remove the battery compartment cover .
• Remove the battery insulation strip.
• Insert the battery, observing the correct polarity. The "+" sign must be uppermost.
• Place the battery into the battery compartment.
• Close the battery compartment by putting the battery compartment cover back on and sliding it up to the end until you hear it engage.
• If the device do not appear to work, check that the battery has been inserted correctly and reinsert it if necessary.

Operation

Switching the appliance on

• Lightly push the slider on the side of the appliance downwards. The display switches itself on. The appliance is ready for use after the sounding of a signal tone and the appearance of "0.0 psi", "0.00 BAR" or "0 kPa" in the LC-display .

Measuring the tyre pressure

Note: The tyre pressure can only be correctly determined on cold tyres.

• Lightly push the slider downwards several times to switch between the air pressure measuring units "BAR", "psi" and "kPa" in the LC-display .
• Place the tyre gauge with the support onto the air pressure sensor so that air can escape from the valve.
• Wait for a short period and then remove the tyre gauge to read off the measurement in the LC-display . On a subsequent remeasurement the measured value is updated.

Measuring the tread depth

• Push the slider all the way to the top so that the measuring tine is visible. The prompt "mm" appears in the LC-display .
• Place the measuring tine into a tread groove in the middle of the tyre imprint (the imprint is the area of the tyre that touches the ground when driving straight ahead).
• Press the tyre gauge onto the the upper surface of the tyre and then carefully remove the appliance from the tyre.
• Read off the tread depth in millimeter from the LC-display . The indicator blinks on tread depth readings less of 4 mm. The indicator blinks and alarm sound on tread depth reading of 2 mm or less.

Switching the appliance off

If the appliance is not used within a period of approx. 35 seconds it switches itself off automatically.

• You can also switch the device off manually by pushing down the slider and holding it there until the LC-display extinguishes.

Replacing the battery

The battery must be replaced when the symbol appears in the LC-display .

• Open the battery compartment and take out the exhausted battery.
• Insert a new battery (type: 3 V , CR2032) into the battery compartment.
  Note: Make sure you fit the battery the right way round (polarity). The correct polarity is shown inside the battery compartment.
• Close the battery compartment cover .

Cleaning and care

• Do not under any circumstances use liquids or cleaning agents, as they will damage the device.
  • Clean only the outside of the device with a soft, dry cloth.
  • Use a slightly dampened cloth to remove more stubborn dirt.

Disposal

The packaging is made entirely of recyclable materials, which you may dispose of at local recycling facilities.
Contact your local refuse disposal authority for more details of how to dispose of your worn-out product.

To help protect the environment, please dispose of the product properly when it has reached the end of its useful life and not in the household waste.

Information on collection points and their opening hours can be obtained from your local authority.

Faulty or used batteries must be recycled in accordance with Directive 2006 / 66 / EC. Please return the batteries and / or the device to the available collection points.

Environmental damage through incorrect disposal of the batteries!

Batteries may not be disposed of with the usual domestic waste. They may contain toxic heavy metals and are subject to hazardous waste treatment rules and regulations. The chemical symbols for heavy metals are as follows: Cd = cadmium, Hg= mercury, Pb = lead. That is why you should dispose of used batteries at a local collection point.

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download ULTIMATE SPEED Z30013A, Z30013B - Tyre Pressure & Depth Gauge Manual