3. Hardware Installation
3.2 Device Installation and Cabling
Step 1: Install the bracket in the
accessory box on the back of the PMA
device.
Step 3: Properly punch holes with
cardboard template and install the
bracket.
Step 5: Remove the PMA and use a
32mm hole opener to cut the hole. Polish
any sharp hole edge to prevent
breakage of any wires.
GDC PMA-2000 INSTALLATION MANUAL
Step 2: Use the cardboard in the PMA
device as a template to determine the
position of the mounting holes.
Step 4: Install the PMA on the bracket
and mark the position of the outlet port
on the distribution box using a marker.
Step 6: Install PMA threading and connect
the corresponding incoming and outgoing
power supply wires according to the device
labels.
- 10 -
th
November 13
, 2020