Tait T2000 II Series Service Manual page 96

5.16 Fault Finding
Mode/State
2010: all channel
LEDs on
Program mode
2015: display shows
"00"
AUX LED flashing.
AUX/SCAN LEDs
Cloning mode flash if clone failed.
Target radio in pro-
gramming mode.
Manual Test Mode
(MTM)
[AUX] = clone
[CALL] = program
Key pressed at
power-up
(control head test)
Front panel shows
Computer Control- normal radio state
led Test Mode (not a separate
(CCTM) mode)
CCI mode
No special power-
up sequence - nor-
mal radio state
immediatly dis-
Normal radio played
mode
Software version #
indicated for a
short time as
"h.nn". "h" is
shown with the
PTT on power-up in Busy and TX LEDs
MTM or normal as a hex number.
mode "n's" are indicated
by the two lower
rows of LEDs
(2010), or by the
channel display
(2015).
31/10/96
T2010/T2015 T2020
Display shows
"-PROG-"
Top row LEDs on
Display shows
"CLONING" Top
row LEDs on. Tar-
get radio in pro-
gramming mode.
Any key on the
control head & any
mode.
All LEDs & all LCD
segments are set
flashing indefi-
nitely
Display shows
"-AUTOTEST-" Top
row LEDs on
Normal display
"CCI BUSY" & top
row LEDs on when
processing a com-
mand or in 'lockout
all' mode
Programmable
power-up message
displayed for a
short time then nor-
mal radio display
(default mode)
Display shows
"xxxx nn.mm" for a
short time, nn =
major, mm = minor
version number
Table 5.2 Radio Mode/Status Display
T2030/T2035
Top row + C1 LEDs Display shows
all on (if fitted) "-PROG-"
T2033/35: display Top row LEDs on
shows "-UU"
All LEDs on for a Display shows
short time then "chan xxxx" (xxxx
indicate radio sta- = last channel
tus. number). LEDs
C1 to C4 show last indicate radio sta-
channel (if fitted). tus
T2035: display
shows "- - -" briefly
C1 key (if fitted) in Any key on the
MTM control head & any
- a front panel key/ mode. All LEDs &
LED test is initi- all LCD segments
ated - all LEDs on are set flashing
initially indefinitely
Top row + C2 LEDs Display shows
(if fitted) all on. "AUTOTEST"
T2035: display Top row of LEDs on
shows "- - -" contin-
uously
Normal display
"CCI BUSY" & top
row LEDs on when
processing a com-
mand or in 'lockout
all' mode.
T2030: own number Own number dis-
as CD on 3 rows of played for a short
LEDs, then last time after power-
number on C1 to up then program-
C4 & DESP LEDs. mable power-up
Others as labelled. message followed
T2035: Own by normal radio
number briefly on display
display, then last
number called.
T2030: 3 rows of
Display shows
LEDs display the
"xxxx nn.mm" for a
software version #
short time, nn =
for a short time as
major mm = minor
h.nn (h is a hex
version number,
number) then as
per selected mode.
then as per
T2035: software
selected mode
version number
on display.
M2000-00
T2040
Copyright TEL