Maintenance - EXEL 5156 Original Operating Instructions

locking handle (28) is locked firmly.
• Follow the same instruction of "Slide cutting"..
COMPOUNDBEVEL&MITRE CUT
• This sawing operation combines a mitre angle with a bevel angle.
• Adjust the turntable (16) to the required mitre angle. Make sure the turntable
locking handle (12) is locked firmly.
• Adjust the saw blade (7) to the desired bevel angle. Make sure the bevel angle
locking handle (28) is locked firmly.
• Follow the same instruction of "Slide cutting".

MAINTENANCE

WARNING: Remove the plug from the socket before carrying out any
adjustment, servicing or maintenance.
1. When all the adjustments, settings or maintenance have been done, make sure
that all keys and wrenches have been removed and that all screws, bolts and other
fittings are securely tightened.
2. Keep the tool's air vents unclogged and clean at all times. Occasionally you may
see sparks through the ventilation slots. This is normal and will not damage your
power tool.
3. Regularly check to see if any dust or foreign matter has entered the grills near the
motor and around the trigger switch. Use a soft brush to remove any accumulated
dust.
4. Wear safety glasses to protect your eyes whilst cleaning.
5. If the body of the saw needs cleaning, wipe it with a soft
damp cloth. A mild detergent can be used but nothing like
alcohol, petrol or other cleaning agent.
6. Never use caustic agents to clean plastic parts.
CAUTION！ Water must never come into contact with the saw.
7. Store the tool, instruction manual and accessories in a
secure place. In this way you will always have all the
information and parts on hand.
GENERAL INSPECTION
1. Regularly check that all the fixing screws are tight. They may vibrate loose over
time. Check especially the outer flange. If there is vibration, screws can loosen with
time.
2. Regularly check the device's power cable and all extension cables used for
damage. If the supply cord needs replacing, the task must be carried out by the
manufacturer, the manufacturer's agent, or an authorized service centre in order to
avoid a safety hazard. Replace damaged extension cables.
3. If the carbon brushes need to be replaced, have this done by a qualified repair
person (always replace the two brushes at the same time).
12