Table of Contents
Advertisement
OPERATION
TRANSPORTATION
1. When transporting the saw with fixed locations, make sure that the saw head is
locked in the lower position.
2. The rotary table locking knob, the bevel lock knob and slide lock must all be
securely tightened.
3. The saw is switched off and the plug is removed fromthe power point.
4. Only lift the saw by the operating handle (1) or outer castings. Do not lift the saw
using the guards.
5. For locking the saw head in the down position, Apply downward pressure on the
operating handle (1) and pull out the release bolt (32), rotate the release bolt to
lock the saw head. The head will be locked in down position.
TURNINGON ANDOFF
1. To turn the saw on, push switch lock (2) and depress the on/off trigger switch (24).
2. To turn the saw off release the on/off trigger switch (24).
Laser ON/OFF
Switch ON/OFF the Laser lights with the ON/OFF switch (33). Press laser switch
at "Ⅰ" place to ON, Press at "0" place to OFF.
SLIDE CUTTING
• To slide cut wide boards, Unlock the slide lock knob (23) and allow the cutting head
assembly to move freely.
• Pull the operating handle (1) forwards until the centre of the saw blade (7) is directly
over the front edge of the workpiece.
• Hold the operating handle (1) firmly and push switch lock (2) and depress the on/off
trigger switch (24). Allow the saw blade (7) to reach maximumspeed.
• Slowly lower the blade to the workpiece.
• Only apply proper feeding force. Excessive feeding force will not increase but lower
the performance of the product, overheat the blade tips and leads to low cutting
surface/edge quality.
• Switch the product off and allow the saw blade to come to a complete stop before
lifting it from the workpiece.
MITRE CUT
• Mitre cutting is the same as cutting, except that the mitre angle is set to an angle
other than 0°.
• Adjust the turntable (16) to the required mitre angle. Make sure the turntable
locking handle (12) is locked firmly.
• Follow the same instruction of "Slide cutting".
BEVEL CUT
• Bevel cutting is the same as cutting, except that the saw blade bevel angle is set to
an angle other than 0°.
• Adjust the saw blade (7) to the desired bevel angle. Make sure the bevel angle
11
Advertisement
Table of Contents
