Table of Contents
Advertisement
3. Use correct application tools for the product and ensure they in good condition.
4. Keep tight grip on the handles/grip surface.
5.Maintain this product in accordance with these instructions and keep it well
lubricated (where appropriate).
6. Plan your work schedule to spread any high vibration tool use across a number of
days.
CUTTING CAPACITY
• Mitre table angles : 0° to 45° to the left & right
• Bevel cuts : 0° to 45° to the left
• Straight cut at 0° x 0° : 30.5 x 7 cm
• Mitre cut at 0° x 45° : 21.5 x 7 cm
• Bevel cut at 45° x 0° : 30.5 x 3.5 cm
• Compound mitre cut at 45° x 45° : 21.5 x 3.5 cm
• Net weight : 15kg
ACCESSORIES
The Compound Mitre Saw is supplied with the following accessories as standard:
• Saw blade (fitted)
• Multi-tool (6 mmhex key/ cross screwdriver)
• Workpiece Clamp
• Dust bag
• Side support bars x2
• Instruction manual
ASSEMBLE &ADJUSTMENT
Important：Be sure the supply is the same as the voltage given on the rating plate.
Remove the mains plug before carrying out any adjustment or servicing.
Warning！To prevent the accidental starting that could cause possible serous
personal injury, ALWAYS assemble all parts to you saw BEFORE connecting it
to the power supply. The saw should NEVER be connected to a power supply when
you are assembling parts, making adjustments, installing or removing blades, or
when not in use.
1. DUST EXTRACTIONPORT
• To reduce build up of saw dust and maintain top efficiency of cutting, the saw dust
collection can be achieved by clipping a dust bag on the dust extraction port.
• Adust bag (26) is provided for use on you mitre saw. To install it, simply fit the dust
bag over the extraction port (25) on the upper blade guard.
• To empty the dust bag, remove it from the dust exhaust port, open the dust by
unzipping the slide fastener.
• Note: to ensure optimal dust collecting, empty the dust bag when it becomes filled
to approximately 2/3 of its capacity.
8
Advertisement
Table of Contents
