Related Manuals for Jet JCP Series
Summary of Contents for Jet JCP Series
- Page 1 Operating Instructions and Parts Manual JCP Series Cable Pullers 427 New Sanford Road LaVergne, Tennessee 37086 Part No. M-180410 Ph.: 800-274-6848 Revision B1 06/2014 www.jettools.com Copyright © 2014 JET...
-
Page 2: Warranty And Service
JET sells through distributors only. The specifications listed in JET printed materials and on official JET website are given as general information and are not binding. JET reserves the right to effect at any time, without prior notice, those alterations to parts, fittings, and accessory equipment which they may deem necessary for any reason ®... -
Page 3: Safety Warnings
The JET JCP-Series Cable Pullers comply with ANSI/ASME B30.21 standards. The specifications in this manual are given as general information and are not binding. JET reserves the right to effect, at any time and without prior notice, alterations to parts, fittings, and necessary equipment... - Page 4 JCP Series Cable Pullers Fig. 1 A – Handle H – Ratchet Wheel B – Forward/Reverse Latch J – Locking Lever C – Spring K – Bottom Hook D – Pawl L – Snatch Block (models JCP-2, JCP-4 only) E – Wire Rope M –...
- Page 5 Releasing or Lowering Load (Fig. 1) Cable puller is designed to ratchet load tension down one ratchet wheel tooth at a time: While under load, place forward/reverse latch (B) to the position as shown by the dotted lines, freeing the handle (A) to move in the direction of the top hook (N).
- Page 6 JCP Cable Puller Trouble-Shooting Trouble Possible Cause Remedy 1. Broken spring (L). 1. Replace cable puller. Puller will not ratchet. 2. Broken ratchet tooth. 2. Replace cable puller. 3. Frame bent. 3. Replace cable puller. 1. Pawl (D) not in correct 1.
- Page 7 This page intentionally left blank.
- Page 8 427 New Sanford Road LaVergne, Tennessee 37086 Phone: 800-274-6848 www.jettools.com...