JET sells through distributors only. The specifications listed in JET printed materials and on official JET website are given as general information and are not binding. JET reserves the right to effect at any time, without prior notice, those alterations to parts, fittings, and accessory equipment which they may deem necessary for any reason ®...
The JET JCP-Series Cable Pullers comply with ANSI/ASME B30.21 standards. The specifications in this manual are given as general information and are not binding. JET reserves the right to effect, at any time and without prior notice, alterations to parts, fittings, and necessary equipment...
Page 4
JCP Series Cable Pullers Fig. 1 A – Handle H – Ratchet Wheel B – Forward/Reverse Latch J – Locking Lever C – Spring K – Bottom Hook D – Pawl L – Snatch Block (models JCP-2, JCP-4 only) E – Wire Rope M –...
Page 5
Releasing or Lowering Load (Fig. 1) Cable puller is designed to ratchet load tension down one ratchet wheel tooth at a time: While under load, place forward/reverse latch (B) to the position as shown by the dotted lines, freeing the handle (A) to move in the direction of the top hook (N).
Page 6
JCP Cable Puller Trouble-Shooting Trouble Possible Cause Remedy 1. Broken spring (L). 1. Replace cable puller. Puller will not ratchet. 2. Broken ratchet tooth. 2. Replace cable puller. 3. Frame bent. 3. Replace cable puller. 1. Pawl (D) not in correct 1.