Panasonic DMP-BD75 Operating Instructions Manual page 29

Picture
The images from this unit do not appear on
the television.
Picture is distorted.
An incorrect resolution is selected in "HDMI Video
Format". Reset the setting as follows:
1 While the unit is on, press and hold [OK], the yellow
button and the blue button on the remote control at the
same time for more than 5 seconds.
– "00 rEt" is displayed on the unit's display.
2 Repeatedly press [1] (right) on the remote control or
[Í/I] on the unit until "04 PrG" is displayed on the unit's
display.
3 Press and hold [OK] on the remote control or [< OPEN/
CLOSE] on the unit for at least 4 seconds.
Set the item again. (
– When Dolby Digital Plus, Dolby TrueHD, and DTS-HD
audio are not output in bitstream, select "Yes" in "Default
Settings" and make proper settings. (
The unit and television are using different video
systems. Switch the setting as follows:
1 While the unit is on, press and hold [OK], the yellow
button and the blue button on the remote control at the
same time for more than 5 seconds.
– "00 rEt" is displayed on the unit's display.
2 Repeatedly press [1] (right) on the remote control or
[Í/I] on the unit until "05 P/n" is displayed on the unit's
display.
3 Press and hold [OK] on the remote control or [< OPEN/
CLOSE] on the unit for at least 4 seconds.
The system switches from PAL to NTSC or vice versa.
The system used on the disc doesn't match your television.
– PAL discs cannot be correctly viewed on an NTSC
television.
– This unit can convert NTSC signals to PAL60 for
viewing on a PAL television ("NTSC Contents Output"
in the "Picture").
Video is not output in high-definition.
Confirm that "HDMI Video Format" in the Setup menu
are set properly. ( 26)
A black band is displayed around the edge
of the screen.
The aspect ratio of the screen is abnormal.
Confirm the "TV Aspect" is set properly. (
Adjust the aspect setting on the television.
Audio
Cannot hear the desired audio type.
Check the connections and the "Digital Audio Output"
settings.( 9 , 25)
To output audio from a device connected with an HDMI
cable, set "HDMI Audio Output" to "On" in the Setup
menu. ( 26)
26)
27)
26)
Playback
Disc cannot be played.
The disc is dirty. ( 4)
Check the region code. (
Still pictures (JPEG) do not playback
normally.
The images that were edited on the PC, such as
Progressive JPEG, etc., may not playback.
I can't playback BD-Live.
Confirm that this unit is connected to the broadband
Internet. ( 9)
Confirm the "BD-Live Internet Access" settings. (
Confirm a USB device is inserted into the USB port.
( 13)
Network
I can't connect to the network.
Confirm the network connection and settings.
( 9, 11, 26)
Check the operating instructions for each device and
connect accordingly.
7)
24)
29
VQT3B11