Panasonic Toughbook CF-W5LCEZZBM Reference Manual page 72

LAN
Click [Power Management], add or remove check marks for [Allow the computer
C
to turn off this device to save power] and [Allow this device to bring the computer
out of standby] to enable or disable the function, click [OK], and then click
[Device Manager] screen to close.
CAUTION
Be sure to connect the AC adaptor, and enable the power supply.
NOTE
Even when a password is set in the Setup Utility and [Password on boot] is set to [Enable], it is not necessary to input
the password set in the Setup Utility when the computer resumes from standby or hibernation mode.
The Wake up from LAN function will not operate under the following conditions:
• When the computer has been shut down
• When the power switch is slid over for four seconds or longer to turn off the power (e.g., when the computer hangs)
• When the AC adaptor and battery pack are removed from the computer or reattached to the computer
• When [LAN] is set to [Disable] in the Setup Utility
After operations are resumed from standby mode, the screen remains dark. The former screen display will be
restored when the keyboard or Touch Pad is touched.
The computer may start up if accessed by another computer on the network.
The following procedure can be used to prevent startup due to unintentional access by a computer.
Click [start] - [Control Panel] - [Performance and Maintenance] - [System] - [Hardware] - [Device Manager].
A
Double-click [Network adapters], double-click the internal network adaptor, and then click [Power Management].
B
Add a check mark for [Only allow management stations to bring the computer out of standby], click [OK], and
C
then click on [Device Manager] screen to close.
72
on