Emagra BUTTERFLY Assembly Instructions

Used parts
(
Note: Some parts may be different than images)
1. Headrest 2. Backrest
3. Seat+mechanism+armrests
4. Base 5. Gaslift 6. Casters
7. Screws
Model BUTTERFLY
A M8x40 3 pcs Backrest
1 pcs IMBUS
Assembly instructions – model BUTTERFLY
https://www.emagra.cz/cs/m-390-kancelarska-zidle-butterfly
STEP 1
1. Take the seat out of the box
2. Take the backrest out of the box
3. Remove headrest, gaslift, base, casters, screws (1,4,5,6,7)
STEP 3
1. Insert 5pcs
of casters into
the base, then
insert gaslift
into the
opening in the
base
2. Insert the
gaslift into the
corresponding
hole in the
mechanism
STEP 4
1. Fasten headrest
to the backrest
a) Put on b) Click in
c) Slide d) Finished
down
STEP 2
1. Fasten backrest to
the mechanism
2. Tighten the screws
A- 3 pcs to a metal
plate which attaches to
the lower part of the
backrest
User guide
Maintenance and attention
1. The chair can only be used by one
person at a time.
2. Do not use the chair as a stool or
ladder.
3.Do not use the chair unless all
parts are properly assembled.
4.Do not use the chair untill all
screws are properly tightened.
5. If the chair is damaged by
external influences, do not use it
without expert repair.
6. For professional servis, please
contact us by phone +420 463 034
155, or by mail export1@emagra.cz