Proper Use; Care; Faulty Function; Storage And Disposal - DekoLight Multi Dimmer 4 Manual

Product-Notes
Manual
Article No.: 843279

1. Proper Use

This product is only used to control lighting/LED strips and may only be set to normal or not
flammable surfaces. The use must be in sheltered and dry
done indoors.

2. Care

Repairs may only be carried out by a qualified electrician.
Disconnect the entire product from the mains first and allow it to cool down before cleaning or maintaining.
Use a dry or slightly moistened cloth for cleaning.
Never use any chemicals, flammable cleaning agents or abrasives. These may cause damage to the surface
coating and/or the insulators.

3. Faulty Function

Are the lights to be controlled operational/correctly connected?
Check the connected lines (observe polarity +/-)
With DMX control: Was a shielded cable used? Check polarity + / - / Ground!
Disconnect the DMX/wall controller, dimmer and power supply units from the mains for approx. 30 seconds
If the control signal between DMX controller and/or MULTI-LED dimmer(s) is interrupted
(e.g. cable defective or incorrectly connected), the dimmer continues to show the last received one
setting on. After a power failure with no DMX signal, the dimmer goes into „blackout mode".
Mode"
Do the connected LED strips light up when they are operated directly on the power supply unit?
The correct voltage 12/24/48V DC and polarity +/- must be observed.

4. Storage and Disposal

Used electronic devices must be brought back to public collection points and must not be disposed of as
household waste.
Storage in a dry and clean environment. Do not strain the product mechanically during storage.

5. Purchased parts package

● 1x MULTI-LED-Dimmer 4
● 1x User Manual
Deko-Light Elektronik-Vertriebs GmbH 16.02.2023
www.deko-light.com / deko@deko-light.com
Technical Data can be changed without advance notice. Errors excepted. 14 / 20