Panasonic Toughbook CF-T2DWATZKM Operating Instructions Manual page 39

Panasonic toughbook cf-t2dwatzkm: user guide
Table of Contents

Advertisement

Backing Up and Restoring Data
1 Turn the computer on, and press F2 while [Panasonic] boot screen is displayed.
2 Select [Exit] menu, then select [Hard Disk Backup / Restore] and press Enter .
<To create a backup area and divide hard disk into two partitions, for OS and data>
Select [2], enter the partition size (GB), and press Enter .
• You can cancel this operation by pressing 0 .
• The data partition size will be the maximum settable size less the number entered above.
The maximum settable size will differ depending on models.
[At the time of purchase]
The usable hard disk area
9 At the confirmation message, press Y .
The backup area is then created.
10 When the message [You must reboot in order to enable the Backup function.] appears, remove
the recovery CD, and press any key to restart the computer. The computer is restarted, then the
backup process will begin.
11 When the message [[Backup] is complete] appears, press Ctrl + Alt + Del to restart the
computer.
CAUTION
Do not press Ctrl + Alt + Del until the message is displayed.
12 A message will appear advising that a new device has been installed and that the computer must
be restarted to enable the settings. Select [Yes] to restart the computer.
NOTE
The [Boot] menu in the Setup Utility is set to start up from the DVD-ROM & CD-R/RW
drive. Change this setting if necessary.
The next time the backup or restore functions are executed, follow the procedure for [Backing
Up and Restoring Data] (
CAUTION
Before executing the backup function, execute a disk error check (
Do not interrupt the backup or restore functions before completion, for example by turning
off the power or pressing Ctrl + Alt + Del , as this may prevent Windows from starting
up, or may cause data to be lost so that the backup and restore functions cannot be executed.
The Setup Utility will start up.
If a password has been set, enter the Supervisor Password or the User Password.
At the confirmation message, select [Yes], and press Enter .
[After the backup area is created]
Can be accessed from
Windows (Two partitions).
below).
The backup area
Cannot be accessed
from Windows.
page 37).
39

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cf-t2 series

Table of Contents