Start Application Development; Required Hardware; Software Setup; Esp-At Support - Espressif ESP32-C6-DevKitC-1 User Manual

Key Component
ESP32-C6 USB Type-C Port
Boot Bu on
Reset Bu on
USB Type-C to UART Port
RGB LED
J5

Start Application Development

Before powering up your ESP32-C6-DevKitC-1, please make sure that it is in good condi on
with no obvious signs of damage.

Required Hardware

ESP32-C6-DevKitC-1
USB-A to USB-C cable
Computer running Windows, Linux, or macOS
 Note
Be sure to use a good quality USB cable. Some cables are for charging only and do not
provide the needed data lines nor work for programming the boards.

Software Setup

Please proceed to ESP-IDF Get Started, where Sec on Installa on Step by Step will quickly
help you set up the development environment then flash an applica on example onto your
board.

ESP-AT Support

The ESP32-C6-DevKitC-1 supports ESP-AT so ware that provides a set of AT commands
with which you can quickly integrate wireless connec vity features into your product without
a need for embedded applica on development of the module on this development board.
The so ware is available as a pre-built binary that can be downloaded from
repository.
For more informa on about using ESP-AT, including informa on on how to customize pre-
built binaries, please refer to
Descrip on
The USB Type-C port on the ESP32-C6 chip compliant with USB 2.0
Download bu on. Holding down Boot and then pressing Reset ini a
Press this bu on to restart the system.
Used for power supply to the board, as well as the communica on w
Addressable RGB LED, driven by GPIO8.
Used for current measurement. See details in Sec on
ESP-AT User Guide.
Current Measu
ESP-AT