Panasonic Toughbook CF-C1ADACZ6M Operating Instructions Manual page 17

NOTE
l PC Information Viewer
This computer periodically records the management information of the hard disk, etc. The maximum data volume for each
record is 1024 bytes.
This information is only used for estimating the cause in the case when the hard disk goes down by any possibility. They
are never sent to outside via network nor used for any other purpose except for the purpose described the above.
To disable the function, add the check mark for [Disable the automatic save function for management information history]
in [Hard Disk Status] of PC Information Viewer, and click [OK]. When you disable the function, information on how to use
the hard disk of PC Information Popup is not displayed.
(è Reference Manual "Check the Computer's Usage Status" "PC Information Popup")
l You cannot choose the following words for user name and password: CON,
PRN, AUX, CLOCK$, NUL, COM1 to COM9, LPT1 to LPT9.
l When you set date/time/time zone and click [Next], the screen may not go to the
next step for a few minutes. Do not touch the keyboard or touch pad, and wait
until the screen changes.
l If "An unexpected error has occurred ..." (or a similar message) is displayed,
click [OK]. This is not a malfunction.
7 Perform the screen calibration.
NOTE
l
Before performing the calibration, close Tablet PC Input Panel.
l Before performing the calibration, rotate the display to primary landscape.
A Click (Start) - [All Programs] - [Panasonic] - [Calibration Utility].
B If [User Account Control] is displayed, click [Yes].
C <Only for model with digitizer>
(1) Click [Pen input (digitizer)].
(2) Using the digitizer pen, touch each of the "+" target marks one by one,
and then click [Yes].
(3) Click [Touch input].
(4) Using your finger, touch each of the "+" target marks one by one, and
then click [Yes].
<Only for model with touchscreen>
(1) Click [Start].
(2) Using the stylus, touch each of the "+" target marks one by one, and then
click [Yes].
A Click [start] - [All Programs] - [Panasonic] - [Calibration Utility].
B <Only for model with digitizer>
(1) Click [Pen input (digitizer)].
(2) Using the digitizer pen, touch each of the "+" target marks one by one,
and then click [Yes].
(3) Click [Touch input].
(4) Using your finger, touch each of the "+" target marks one by one, and
then click [Yes].
<Only for model with touchscreen>
(1) Click [start].
(2) Using the stylus, touch each of the "+" target marks one by one, and then
click [Yes].
8 Create a new account.
Click [start] - [Control Panel] - [User Accounts] - [Create a new account].
CAUTION
l Remember your password. If you forget the password, you cannot use the Win-
dows operating system. Creating a password reset disk beforehand is recom-
mended.
17