Panasonic Toughbook CF-74JCL02AM Reference Manual page 86

Hardware Diagnostics
Regarding the PC-Diagnostic Utility
NOTE
For the hard disk and memory only, you can select standard diagnostic check or extended diagnostic check. When the
PC-Diagnostic Utility starts up, it will run the standard diagnostic check.
We recommend that you use the touch pad for operations. When not using the touch pad, you can operate using the inter-
nal keyboard instead. Do not use the touchscreen.
Operations
Select icon
Click the icon
Complete the PC-Diagnostics Util-
ity and then restart the computer
If the touch pad does not operate properly, press Ctrl + Alt + Del to restart the computer, or press the power switch to
turn the power off, and then restart the PC-Diagnostic Utility.
Running the Diagnostic Check
Run this utility using the default settings in the Setup Utility.
If the Setup Utility or other settings will not allow hardware to be executed, the hardware icon will be displayed in gray.
1
Connect the AC adaptor, and turn on the wireless switch (
During the diagnostic check, do not remove the AC adaptor, or attach any peripheral devices.
2
Turn on or restart the computer, and press
played.
The Setup Utility starts up.
If the password is requested, enter the Supervisor Password.
If you are using the computer after changing the settings from the status at the time of purchase, we recommend
that you make a note of the settings that are changed.
3
Press .
F9
At the confirmation message, select [Yes] and press Enter.
4
Press .
F10
At the confirmation message, select [Yes] and press Enter.
The computer will restart.
Touch pad operations
Place the cursor above the icon
Tap or click (right click cannot be used)
Click (close)
F2
Internal keyboard operations
Press Space, and then press
( (close) cannot be selected)
Press Space above the icon
Press Ctrl + Alt + Del
page
or while [Panasonic] boot screen is dis-
Del
86

65).