Sharp KA-73G68BNH-PL User Manual page 50

On/Off
Defrost
Turbo
Function
Bottom
Function
Static
Function
Fan
Function
Pizza
Function
Function
Menu
The control unit will switch off after 5
minutes if no function is selected or
changed.
The appliance is operated using touch
control sensors. The functions are
controlled by touching the sensor fields.
When you are using the controls, make
sure that you touch the sensor field
correctly. If your touch is too flat or too small
the sensors will not operate correctly.
The cooling fan will switch on automatically
in order to keep the surfaces of the
appliance cool. The fan will continue to run
until it automatically switches off, even after
the oven has been switched off.
Oven Function Selection
Touch the ON/OFF sensor for 2 seconds
to switch the control unit on. The oven will
enter "WAIT" mode. During this mode, you
will be able to select the desired cooking
functions, adjust the temperature, activate
the BOOST function, as well as adjust the
cooking time, end time, Minute Minder timer
and the time of day.
During "WAIT" mode, the desired cooking
function can be selected by touching the
sensor button. Each touch on the
sensor will change the oven function, as
shown below (some of these cooking
functions may not be present in your cooker
model):
Defrost → Turbo → Bottom→Bottom and
Top →Bottom and Top with Fan →Pizza
Function Description
Faster
Grilling
Function
Double
Grill + Fan
Function
3D Function
Cleaning
Function
Temperature
Display
Time Display
Mode
→ Faster Grilling (with/without turnspit) →
Double Grill with Fan (with/without turnspit)
→ 3D →Vap clean
The operated heaters related to the
selected function will be displayed.
When a cooking function is selected using
the
temperature value will show on the
Temperature display. This can be adjusted
using the PLUS and MINUS sensor buttons
on the side of the display. The temperature
can be adjusted within the range of 50°C to
275°C.
After the desired function has been
selected, and the temperature and time are
set, touch the PLAY/PAUSE sensor to start
the oven function operation.
Adjusting the Time of Day
When the oven has been installed, the
time of day must be set according to the
following instructions.
Touch the ON/OFF
oven on and enter "WAIT" mode. During
this mode, touch the MODE(
button for 5 second until the
selected. The symbol for the time will
illuminate on the left side and you can
adjust it using the PLUS and MINUS sensor
buttons. To complete the time adjustment,
touch the MODE(
do not touch any
The time will only have to be set again if the
appliance is disconnected from the power
EN - 18
Auto Cooking
Temperature
Bar
Thermostat
Minus
Plus
Key Lock
Play/Pause
sensor, the previously selected
sensor to switch the
) sensor once again or
button for 3 second.
Meat probe stop
Meat Probe
Cooking Time
Cooking end
time
Minute Minder
Boost
Steam Function
)sensor
day time is