danalock Universal Module V3 Manual page 5

Click commands
You can configure the Universal Module via the button found in
the small hole on the module. When you get to the setting you
want, wait for 5 seconds and the Universal Module will react. If you
make a wrong number of clicks, just stop at an unmarked number
of clicks and wait for 5 seconds. The LED will flash red.
Clicks
1
This command is for setting up the Universal Module with a smart home gateway
such as Z-Wave or ZigBee (not HomeKit). The Universal Module will respond by
blinking green. Now the module is in ex/inclusion mode and you have 30 seconds to
pair or unpair it with a gateway.
10
Deletes all settings and all keys on the Universal Module. The Universal Module will
respond by blinking red.
Color
Green
Red
Activity
Inclusion mode
Reset the Danalock
5