Page 2
Notice Add liquid medication before turning on device. Do not use products containing oil or liquid atomization. Follow doctor's advice on medication selection, usage and treatment time. Use clean water for nebulization. Do not use distilled water, multiple-filtered purified water or oil substances.
Operating Steps To open lid, turn counter-clockwise. Add proper liquid medication. Do not exceed the max scale indication.
Page 4
Tighten the lid by turning clockwise. Connect mask or mouthpiece.
Page 5
Start nebulizing. Tip: Before nebulizing, shake slightly to ensure solution makes contact with nebulizer. If the green light flashes three times, please ensure you have enough liquid medication in the chamber. If there is sufficient medication, wait until green light flashes, then restart device with the power button to finish treatment.
Page 6
The provided USB cord is not meant to be used with any other electronic equipment. Keep all contact points clean and dry after use.
Page 7
Cleaning Guidance 1. Preliminary Cleaning Turn the cap counter clockwise to loosen and remove from unit. Remove mouthpiece or mask with a twist. Open the lid and pour out any liquid medication residue.
Page 8
Add appropriate amount of clean, warm water (Below 104° F). Do not use distilled water or multiple-filtered purified water. Tighten the lid.
Run the nebulizer. Wipe the outside of the machine with clean medical gauze after nebulization cleaning. Do not touch the central area of the mesh in order to avoid damaging. 2. Regular Cleaning Hold down the cup release (”PRESS”) button and pull out the medication cup.
Page 10
Clean the inside of medication cup Clean the outside Clean the inside of the misting of the misting connector interface connector interface Wash the outside and inside of the medication cup and with clean water (Below 104° F). Dry with clean medical gauze.
Need help?
Do you have a question about the NEB402 and is the answer not in the manual?
Questions and answers