SUNSET NEB402 User Manual

Handheld mesh nebulizer
Hide thumbs Also See for NEB402:

Advertisement

User Guidance
Handheld Mesh Nebulizer
NEB402
IFU-00073 REV 1.00
2022-08-26

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NEB402 and is the answer not in the manual?

Questions and answers

Summary of Contents for SUNSET NEB402

  • Page 1 User Guidance Handheld Mesh Nebulizer NEB402 IFU-00073 REV 1.00 2022-08-26...
  • Page 2 Notice Add liquid medication before turning on device. Do not use products containing oil or liquid atomization. Follow doctor's advice on medication selection, usage and treatment time. Use purified water for nebulization. Do not use distilled water, multiple-filtered purified water or oil substances.
  • Page 3: Operating Steps

    Operating Steps To open lid, turn counter-clockwise. Add proper liquid medication. Do not exceed the max scale indication.
  • Page 4 Tighten the lid by turning clockwise. Connect mask or mouthpiece.
  • Page 5 Start nebulizing. Tip: Before nebulizing, shake slightly to ensure solution makes contact with nebulizer. If the green light flashes three times, please ensure you have enough liquid medication in the chamber. If there is sufficient medication, wait until blue light flashes, then restart device with the power switch to finish treatment.
  • Page 6 This plug is not meant to be used with any other electronic equipment. Keep all contact points clean and dry after use.
  • Page 7: Cleaning Guidance

    Cleaning Guidance 1. Preliminary Cleaning Turn the cap, mouthpiece or mask clockwise to loosen and remove from unit. Open the lid and clean the liquid medication residue.
  • Page 8 Add appropriate amount of warm water (Below 104° F). Do not use distilled water or multiple-filtered purified water. Tighten the lid.
  • Page 9: Regular Cleaning

    Run the nebulizer. Wipe the outside of the machine with clean medical gauze after nebulization cleaning. Do not touch the central area of the mesh in order to avoid damaging. 2. Regular Cleaning Hold down the press button and pull up the medication cup.
  • Page 10 Clean the inside of medication cup Clean the outside Clean the inside of the misting of the misting connector interface connector interface Wash the outside and inside of the medication cup and misting connector interface repeatedly with purified water (Below 104° F). Dry with clean medical gauze. Do not touch the center of the mesh in case of damage.

Table of Contents