3.0 C ORDREEL NSTALLATION 3.1 Before You Start the Installation There are a few requirements that need to be followed in the planning of your installation; • The shore power cable routing from the Cord reel to where it exits the boat (normally through a hatch or Hawse Pipe).
Page 5
3.5 Installing the Hawse Pipe (optional accessory) Part#: 04079-CRM — Hawse Pipe w/ Guide Roller Assembly The installation of the Hawse Pipe is optional. 04079-CRM-LS — Hawse Pipe w/ Guide Roller In- You may also use your existing Hawse Pipe or any Limit Switch Assembly storage space door that is accessible to where you Clearance hole 17/64...
3.7 DC Wire Connection The Cordreel comes with (2) 14 gauge wires exiting from the gear motor cover. • These wires should be connected to the 12 or 24 VDC power source depending on unit purchased (see label on unit for correct voltage). •...
UCTS, LLC. option, the complete unit replaced and returned to the consumer, shipping charges prepaid. 5. GLENDINNING PRODUCTS, LLC. does not assume the costs of removal and/or installation of the product or any other incidental costs which may arise as a result of any defect in materials or workmanship.
Page 8
7.0 A CCESSORIES PART# Description 04054 Guide Roller Assembly with Plate Remote Control System 12/24V, Includes (2) transmitters, (1) receiver, (1) 04154-1B antenna, and (1) wire harness 04079-CRM Stainless Steel Hawse Pipe w/ Guide Roller Assembly 04079-CRM-LS Stainless Steel Hawse Pipe w/ Guide Roller Assembly and Limit Switch 04210 Bracketing to install pipe accessories onto unit (See brochure for info) 19846-5...
This manual is also suitable for:
Crma 63Crma50-12-63iwCrma50-12-64wCrma50-12-64yCrma50-24-63iwCrma50-24-63w...
Show all