Table of Contents
Advertisement
3.7 DC Wire Connection
10' long Control
Switch Wires
3.8 Control Switch
•
Mount the control switch near where the cable exits
the side of the boat.
•
Connect red quick connector terminal to the tabs on
the control switch.
4.0 O
I
PERATING
NSTRUCTIONS
To operate your Cordreel:
•
PULL OUT only the amount of shore power cord required to reach the
dockside power post connection.
•
CONNECT your shore power cord to dockside power post connection.
•
TURN ON breaker at dockside power post.
When ready to get underway:
•
TURN OFF dockside power post connection.
•
DISCONNECT cord from the dockside power post connection.
•
PUSH AND HOLD the Cordreel power switch . Cordreel will electrically retrieve the power cord and store.
•
When cord is fully retracted, RELEASE the power switch to stop the unit.
6
DC Power Input
• 12 or 24v DC Input (check
label on unit)
RED - DC Positive +
BLACK - DC Negative
• use 15amp breaker or fuse
The Cordreel comes with (2) 14 gauge wires exiting from
the gear motor cover.
•
These wires should be connected to the 12 or 24
VDC power source depending on unit purchased
(see label on unit for correct voltage).
•
Connect wire to DC battery as shown to left.
•
Make sure all connections are secured and protect-
ed from the environment.
!
WARNING:
All wiring should be done in accordance
with ABYC's standards. If you are un-
sure of these standards, consult a quali-
fied electrician.
Cutout for switch is
1" x 1.75"
• Always disconnect AND fully retract
your cable BEFORE getting underway!
• Continuing to push power button
after cable is retracted may cause dam-
age to the motor and will cause breaker
switch to trip - reset before next use.
!
NOTE:
Advertisement
Table of Contents
