Table of Contents
Advertisement
5.0 M
AINTENANCE
•
TO RELIEVE ANY KINKING that may happen Routinely extend the power cable completely, stretch it on any flat sur-
face, and allow the Cordreel to retract the cable into the reel.
•
INSPECT ALL AC AND DC WIRING CONNECTIONS and make sure they are free of corrosion and connections are
tight.
•
IF THE POWER CABLE ACCIDENTALLY FALLS INTO THE WATER, do not use until the cable has been cleaned and
dried fully. See Marine Molded Power Cord Sets 044xx User Guide for more information.
•
INSPECT THE EXTERIOR JACKET of the power cable for nicks or cuts.
•
IF YOUR POWER CABLE IS DIRTY, any cleaner should be compatible with the outer jacket material of the power
cable.
•
IF NEEDING TO REPLACE POWER CORDSET—Contact Glendinning Products, LLC. For replacement cordset. If using
another manufacturer's cordset, USE ONLY 105°c MINIMUM RATED CORDSETS. Also make sure that the outside
diameter of the new cordset does not exceed that of the factory supplied cordset. Contact Glendinning Prods. For
6.0 T
ROUBLESHOOTING
ISSUE
Non-functional (either no power
or unit has power and does not
respond)
Cordreel stops retracting
while button is being pushed
PRODUCT COVERED BY THIS LIMITED WARRANTY: CRMA50/63
1. GLENDINNING PRODUCTS, LLC. warrants to the original consumer purchaser that the CRMA 50/63 will be free from defects in material and workmanship under
normal use and service for a period of one (1) year from the date of purchase.
2. This LIMITED WARRANTY applies to defects in material and workmanship. It does not apply to plated or painted finishes or to cord damage caused by inade-
quate cable storage area or installation not in accordance with GLENDINNING PRODUCTS, LLC. specifications.
3. This LIMITED WARRANTY is void if the product has been damaged by accident or unreasonable use, neglect, improper installation, or other causes not arising
out of defects in material or workmanship.
4. To obtain performance of this LIMITED WARRANTY obligation the original purchaser should contact GLENDINNING PRODUCTS, LLC. for instructions concerning
removal and shipping of the defective component. Upon compliance of the foregoing procedure all warranted defects will be repaired, or at GLENDINNING PROD-
UCTS, LLC. option, the complete unit replaced and returned to the consumer, shipping charges prepaid.
5. GLENDINNING PRODUCTS, LLC. does not assume the costs of removal and/or installation of the product or any other incidental costs which may arise as a result
of any defect in materials or workmanship.
THIS WARRANTY IS IN LIEU OF ALL OTHER EXPRESS WARRANTIES. ANY WARRANTY IMPLIED BY LAW INCLUDING WARRANTIES OF MERCHANTABILITY OR FITNESS, IS
IN EFFECT ONLY FOR THE DURATION OF THE EXPRESS WARRANTIES SET FORTH IN THE FIRST PARAGRAPH ABOVE. NO REPRESENTATIVE OR PERSON IS AUTHORIZED
TO GIVE ANY OTHER WARRANTY OR TO ASSUME FOR GLENDINNING PRODUCTS, LLC. ANY OTHER LIABILITY IN CONNECTION WITH THE SALE OF IT'S PRODUCTS.
GLENDINNING PRODUCTS, LLC. WILL NOT BE LIABLE FOR ANY CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OR INSTALLATION OF IT'S PRODUCTS.
Installation Instructions for replacing Cordsest
PROBABLE CAUSE
Tripped breaker
Blown fuse at power source
Power wire incorrectly connected
to power source
Defective motor
Cord jammed during retraction
causing breaker to trip
Reset breaker
Replace fuse
Check power source fuse and connections,
reconnect or replace if necessary
With power switch on and voltage across motor
wires — if no response, replace motor
Reset breaker
Pay out cable and rewind
WARRANTY
RECOMMENDED ACTION
7
Advertisement
Table of Contents
