International CQ-5400U Operating Instructions Manual page 17

Press and hold
d
or
Cautions:
Be careful not to set wrong alarm time, otherwise, the alarm may sound while driving.
●
If the alarm is set, be sure to check the set alarm time by pressing and holding [ALM] for more than
●
2 seconds.
If volume is set at "0" step, the output volume will be muted. (Even when ALARM is acting.)
●
Alarm Time Setting
Press and hold [ALM] until you have set the alarm time, "AM
12:00" blinks , and the alarm time setting mode is activated.
Press [ i i ] to set the hour.
Press [ j j ] to set the minute.
(Hold [ i i ] or [ j j ] to change numbers rapidly.)
When you have set the alarm time, release [ALM].
Note: When the alarm is not set yet, "AM 12:00" is displayed.
Alarm Time Reset
When you want to reset the alarm time, repeat steps
above.
Alarm Operation
Alarm is switched to ON or OFF each time [ALM] is pressed.
●
When the alarm is switched to ON, the alarm sound will activate
●
at the set alarm time.
Turning off the Alarm Sound
The alarm sound will turn off automatically after 90 seconds.
Otherwise, press [ALM] once.
Alarm output Volume Selection
You can select ALARM VOL 1 (or VOL 2) by pressing [ALM] in
sequence and the display will show as follows.
ALARM TIME
a
(display 3 seconds)
ALM VOL 1
a
(display 2 seconds)
OFF
to
ALM VOL 2
(display 2 seconds)
16