Table of Contents
Summary of Contents for International CQ-5400U
- Page 1 High Power CD Player / Receiver with Changer Control High Power CD Player / Receiver CQ-5400U/5200U Operating Instructions Please read these instructions carefully before using this product and save this manual for future use.
-
Page 3: Use This Equipment Safely
Failure to observe this may cause malfunction due to precise mechanism of this unit. Notes: CQ-5400U can be connected to an optional CD changer (CX-DP801EUC, etc.) and an wired remote ● control unit (CA-RC350U). CQ-5200U can be connected to an wired remote control unit (CA-RC350U). -
Page 4: Table Of Contents
Contents Use This Equipment Safely ..............Page 2 Laser Products ..................Page 4 Part 15 of the FCC Rules ..............Page 4 ❏ Power and Sound Controls ..............5 How to adjust the volume, mute, balance, and tone for best listening ❏ Radio Basics....................8 Mode selection, manual and automatic tuning, band selection, preset stations ❏... -
Page 5: Laser Products
Label indications and their locations ● Certification label Identification label Front Certification Label Identification Label CQ-5400U Product complies with DHHS Rules 21 Model No. CFR, Subchapter J in effect as of date of manufacture. 4~8Ω FM75Ω Matsushita Electric (Taiwan) Co., Ltd. -
Page 6: Power And Sound Controls
Power and Sound Controls Power If the vehicle is not running yet, turn the key in the ignition until the accessory indicator lights. Press [PWR] to switch on the power. Volume Press the knob to select the volume mode and then turn it ●... - Page 7 5 seconds (2 seconds in the VOL mode). S•HDB (Super High Definition Bass) Press and hold (Only for CQ-5400U) Especially for rock music, the bass-sound will be more powerful. Press and hold [BAND] (S•HDB) for more than 2 seconds to be ●...
- Page 8 Press [MUTE] again to cancel. ● Selecting Auxiliary Source Press and hold (Only for CQ-5400U) Press and hold [MODE] (AUX) for more than 2 seconds to select AUX Input mode. Connect the auxiliar y equipment (any other appropriate equipment) to AUX IN Connector.
-
Page 9: Radio Basics
Radio CD changer (when connected) (Press and hold [MODE] for more than 2 seconds.) (only for CQ-5400U) To change to the tuner mode In case of CD changer mode or CD mode, press [MODE]. Selecting a Band Press [BAND] to change the band setting as follows. - Page 10 Radio Basics (continued) Station Preset FM1, FM2 and AM can save maximum 6 stations each in their preset station memories. Caution: To ensure safety, never attempt to preset stations while you are driving. Manual Station Preset Press [BAND] to select a desired band. Use manual or seek tuning to find a station which is to be preset in the memory.
- Page 11 Tuning in a Weather Band Station Press any of the buttons [1] to [6] to tune in the station preset by the previous page. The frequency (162) remains unchanged. Weather Band Frequency Channel Number Note: The weather band (CH1-6) has been preset in advance. CH7 is selected by pressing [ j j ] or [ i i ].
-
Page 12: Compact Disc Player Basics
Compact Disc Player Basics Disc Insert Insert the disc and play starts automatically. "LOAD" will be displayed until the disc is loaded. Play starts from the first track. Caution: Do not use irregularly-shaped (heart-shaped, octagon etc.) CD. Failure to observe this may cause malfunction. Note: While the disc is in the deck, "... - Page 13 Track Repeat Press [3 REP] to repeat the current selection. ● REPEAT Press [3 REP] again to cancel. ● Random Selection Press [6 RAND](RAND: RANDOM). A random selection of music ● is played from all available tracks. RANDOM Press [6 RAND](RAND: RANDOM) again to cancel. ●...
-
Page 14: Cd Changer Basics
CD Changer Basics (Only for CQ-5400U) Note: CD changer functions are designed for an optional CD changer unit. Starting the CD Changer Press and hold Once the CD changer has been connected, press [MODE] to change to the CD changer mode. when a disc magazine is inserted, CD play starts automatically. - Page 15 Track Repeat Press [3 REP] to repeat the current selection. "REPEAT" indicator ● lights. REPEAT Press [3 REP] again to cancel. ● Random Selection Press [6 RAND](RAND: RANDOM). A random selection of music ● is played from all available discs/tracks. RANDOM Press [6 RAND](RAND: RANDOM) again to cancel.
-
Page 16: Clock Basics
Clock Basics (The clock system is 12-hours.) Initial Time Press and hold Press and hold [CLK] until you have set the time, "AM 12:00" blinks, and the time setting mode is activated. Press [ i i ] to set the hour. Press [ j j ] to set the minute. - Page 17 Alarm Time Setting Press and hold Press and hold [ALM] until you have set the alarm time, "AM 12:00" blinks , and the alarm time setting mode is activated. Press [ i i ] to set the hour. Press [ j j ] to set the minute.
- Page 18 If abnormal Operation appears Reset Switch Use a unflexible thin stick to press this switch in the hole. The initial settings will resume and all electronic memory settings previously registered will be lost.
-
Page 19: Installation Guide
Installation Guide WARNING This installation information is designed for experienced installers and is not intended for non-technical individuals. It does not contain warnings or cautions of potential dangers in attempting to install this product. Any attempt to install this product in a motor vehicle by anyone other than qualified installer could cause damage to the electrical system and could result in serious personal injury or death. - Page 20 ❏ Installation Procedures When bending the mounting tab of the mounting collar with a screwdriver, be careful not to injure ● your hands and fingers. We strongly recommend you to wear gloves for installation work to protect yourself from injuries. ●...
- Page 21 To remove the unit from the vehicle's dashboard Insert Dismounting Pins and pull both pins. Dimounting Pin (U-shaped) Note: Do not lose Dismounting Pins. They will be needed to remove the unit from the vehicle's dashboard.
- Page 22 Electrical Connections (only for CQ-5400U) Cautions: This product is designed to operate with a 12-volt negative ground battery system. ● To prevent damage to the unit, be sure to follow the connection diagram below. ● Do not insert the power connector into the unit until the wiring is completed.
- Page 23 Electrical Connections (only for CQ-5200U) Cautions: This product is designed to operate with a 12-volt negative ground battery system. ● To prevent damage to the unit, be sure to follow the connection diagram below. ● Do not insert the power connector into the unit until the wiring is completed. ●...
-
Page 24: Troubleshooting
Troubleshooting Error Display Messages ❏ Maintenance Appears on the display when the Your product is designed and manufactured to compact disc is dirty or inverted. ensure a minimum of maintenance. Use a soft The disc is ejected automatically. cloth for routine exterior cleaning. Never use But, the disc may be ejected benzine, thinner, or other solvent. - Page 25 Troubleshooting (continued) ❏ Troubleshooting Tips PROBLEM POSSIBLE CAUSE PROBABLE SOLUTION Unit does not turn on. Dead vehicle battery Charge vehicle battery. Ignition or ACC is not on. Turn ignition to On or ACC. Bad power line connection Check connections. Radio has static. Antenna not hooked up Hook up antenna.
- Page 26 Special Notes Notes on Compact Discs ONLY USE DISCS CARRYING LABEL SHOWN ON THE RIGHT Label Dirt, dust, scratches and bending of disc will cause ● misoperation. Handle discs with care. Do not place stickers or make scratches on disc. ●...
-
Page 27: Specifications
Specifications General Power Supply : 12 V DC (11V-16V) Test Voltage 14.4V, Negative ground × 4 channels at 400 Hz, Volume Control maximum Maximum Power Output : 37 W Power Output : 18 W per channel into 4 ohms, 40 to 30,000Hz at 3% THD. Tone Action : Bass;... - Page 28 Panasonic Consumer Electronics Company, Division of Matsushita Electric Corporation of America One Panasonic Way, Secaucus, New Jersey 07094 YFM284C336ZA TAMACO0900-0 Printed in Taiwan...