CaryMart S1US-DC Manual

RF Wireless Remote Control Radio Controller / Transmitter & Receiver

Package Include:

1 x Receiver: S1US-DC(4~12V) (1 Channel / Three Control Modes)
1 x Transmitter: C-2
1 x User manual

Feature:

Wireless control, easy to install
Control Lights, Motors, Fans, electrically operated Doors/Locks/Windows/Blinds/Cars or Other Appliances with voltage AC110~240V or
DC0~28V.
You can turn on/off the receiver with transmitter (remote control) from any place within a reliable distance; the wireless RF signal can pass
through walls, floors and doors.
With characteristics of reverse power protection and over current protection
Audible / visual indication
Use an 8-bit microcontroller with low-power and high-speed CMOS technology.
Reliable control: The transmitter (Encoding) and the receiver (Decoding) use an 8-bit code.
One/ several transmitters can control one/ several receivers simultaneously.
If you use one or more receivers in the same place, you can set them with different codes.
Transmitting Frequency: 315MHz
Receiver:
Model No.: S1US-DC(4~12V)
Channel: 1 CH
Control Modes: Momentary, Latched, Toggle
Coding Type: Fixed code
Coding Setting: By learning
Power Supply (Operating Voltage): DC 4~12V
Output: Relay output (Normally open and normally closed)
Working Voltage Range of Relay: AC110~240V or DC0~28V
PCB Size: 25mm x 11mm x 7mm
Static Current: ≤7mA
Maximum Working Current of Relay: 2A
Receiver Working Current: 30mA
Transmitter:
Model No.: C-2
Channel: 2 CH
Remote Control Distance: 50m / 150ft (theoretically)
Encode: Fixed code by soldering
Unit Size: 58mm x 39mm x 16mm
Power Supply: 1 x 23A -12V battery (included, can be used for 12 months)

Usage:

Setting different control modes (We have set the receiver as Latched control mode before delivery. If you want to use other control modes, do as
following operation):
Setting control mode Toggle: Do not connect
Control mode Toggle: Press -> On; Press again -> Off.
Press button 1: Turn on the relay (connect B and C, disconnect A and B)
Press button 1 again: Turn off the relay (disconnect B and C, connect A and B)
Setting control mode Momentary: Connect terminal 1 and 2
Control mode Momentary: Press and hold -> On; Release -> Off.
Press and hold button 1: Turn on the relay (connect B and C, disconnect A and B)
Release button 1: Turn off the relay (disconnect B and C, connect A and B)
Setting control mode Latched: Connect terminal 3 and 4
Control mode Latched: Press -> On, other relays Off; Press another button -> Off.
Press button 1: Turn on the relay (connect B and C, disconnect A and B)
Press button 2: Turn off the relay (disconnect B and C, connect A and B)

How to pair the transmitter to the receiver:

1) Connect setting terminals until LED on; disconnect setting terminals, the receiver enters into status of LEARNING.
2) Press and hold button 1 on remote control, LED flash once, release button 1; then press and hold button 2 on remote control, LED flash once
again; finally, press any one button on remote control. If LED off, it means learning is successful.
3) The receiver can learn 6 buttons with different codes.
SHENZHEN GUIYUAN INDUSTRY DEVELOPMENT CO.,LTD
Http://www.carymart.com E-Mail: sale@carymart.com