Table of Contents
Advertisement
Installation Instructions - LSR6B / LSSQR6B Commercial LED Rough-In
Cleaning
To Clean Trims:
1.
Press in on white plastic latch to remove upper
reflector and clean lens (Figure 12 & 13).
2.
Gently wipe with soft, clean, dry lint-free cloth to
remove dust.
3.
Wipe with mild detergent solution on a soft, clean
cloth to remove fingerprints and stains.
4.
Rinse with clean water and dry with soft, clean, dry
lint-free cloth.
Electrical Connection
CAUTION
Make certain no bare wires are exposed outside of wire nut
connectors.
1.
Provide electrical service according to the "National
Electrical Code" or your local electrical code to the
cylinder housing assembly. Supply wire insulation must
be rated for at least 90°C (Figure 10).
2.
Connect supply lead wires to cylinder housing lead
wires (line, neutral and ground) in the fixture using the
provided lever nut connectors. Be careful not to leave
any bare conductors outside of the connectors.
3.
Lift the orange tab on the lever nut to disengage the
wire and close to secure the wire in place (Figure 14).
4.
Connect white to white, black to black, and green (from
electrical service) on the supply side to the bare copper
wire in the cylinder housing assembly.
White
Plastic Latch
Figure 12
4
COOPER LIGHTING SOLUTIONS IB520112ML
Figure 13
Lever Closed
Close Lever To
Secure Wire
Figure 14
Wiring Diagrams
1.
For D010
BLACK (LINE)
WHITE
(NEUTRAL)
(NEUTRAL)
GROUND
2.
For D010TR
BLACK (LINE)
WHITE (NEUTRAL)
GROUND
Installation Instructions
Release Or Insert
RED
BLACK (LINE)
BLUE
0-10V DIMMING
WHITE
DRIVER
PURPLE
PINK*
RED
BLACK (LINE)
LINE VOLTAGE
BLUE
DIMMING OR
0-10V DIMMING
WHITE (NEUTRAL)
AT 120-277VAC
PURPLE
DUAL DIMMING
DRIVER
PINK*
Upper Reflector
Lens
Lever Open
Open Lever To
Wire
RED
RED
BLACK
LED
BLACK
MOUDLE WIRING
DIAGRAM
0-10V
DIMMING
OPTION
(FIELD
INSTALLATION)
RED
RED
BLACK
LED
BLACK
MOUDLE WIRING
DIAGRAM
0-10V
DIMMING
OPTION
(FIELD
INSTALLATION)
Advertisement
Table of Contents
